Electrical Requirements - KitchenAid KEC56 Manual

PRODUCT SAFETY

ELECTRICAL REQUIREMENTS

Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
Electric outlet:
For your safety and to avoid damage to
your product, it is very important that your
product is earthed correctly.
Your appliance power cord features a
hexagon-shaped plug, 10A, per ABNT
(NBR 14136).
Your residence electrical installation must
have a suitable electric outlet for this type
of plug. If not, it is your responsibility to
have one installed by a qualified electrician.
Use appropriate outlet type for your
appliance plug, as shown below:
Before operating this
appliance, make sure
the main voltage at
the installation site is
the same as indicated
on product technical
data label.
This information is also included on the
label attached to your appliance's cord
near the plug.
4
W11604421A.indb 4 W11604421A.indb 4
Voltage: 127 V & 220 V
Frequency: 60 Hz
NOTE: The power rating for your Stand
Mixer is printed on the serial plate.
Use an appropriate outlet to plug in your
Stand Mixer. If the plug does not fit in the
outlet, contact a qualified electrician. Do
not modify the plug in any way. Do not
use adapters or T's.
Do not use an extension cord. If the
power supply cord is too short, have a
qualified electrician or service person
install an outlet near the appliance.
The maximum rating is based on the
attachment that draws the greatest
load (power). Other recommended
attachments may draw significantly less
power.
IMPORTANT:
• If it is necessary to convert your 127V
appliance to 220V, use a 1.0 KVA
stabiliser.
• If it is necessary to convert your 220V
appliance to 127V, use a 1.0 KVA
stabiliser.
• Never plug your
appliance into
multiplug adapters
with another
appliance in the same
socket. Do not use an
extension cord. This type of connection
may cause electrical overload in the
mains, and can damage the appliance
and could cause a fire. The appliance
should be plugged into its own outlet.
• In case of oscillation in mains voltage,
install an automatic voltage stabiliser
with minimum rating of 1500 Watts
between the appliance and the socket.
• If the cord of this appliance is damaged,
it must be replaced. Contact your
nearest authorised KitchenAid Customer
Care Centre.
6/16/2022 11:21:20 AM 6/16/2022 11:21:20 AM