Table of Contents
Advertisement
Interrupting the programme
Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
connection or is heated, always leave
the door ajar for several minutes and
then close it.
Switch off ON/OFF switch (.
1.
The LEDs go out. The programme is
saved.
Switch on the ON/OFF switch (
2.
again to continue the programme.
Terminating the programme
(Reset)
Open the door.
1 .
T e r m i n a t i n g t h e p r o g r a m m e
Press the START button ` and
2.
hold it down for about 3 seconds.
The value ‹:‹‚ appears in the
display window h.
Close the door. The programme
3.
sequence lasts about 1 minute.
The value ‹:‹‹ appears in the
display window h.
Open the door.
4.
Switch off ON/OFF switch (.
5.
Close the door.
6.
Changing the programme
When the START button ` has been
pressed, the programme cannot be
changed. The only way a programme
can be changed is by Cancel
programme (Reset).
Operating the appliance en
ExtraDry
The final rinse uses a higher
temperature which improves the drying
result. The running time may increase
slightly. (Be careful if you have delicate
tableware)
Here's how to change the setting:
Switch on ON/OFF switch (.
1.
Hold down the programme button
2.
# and then repeatedly press the
START button ` until •:‹...
appears in the display window h.
Release both buttons.
3.
The LED of the # button flashes
and the digital display h shows
the factory setting •:‹....
Press the programme button #
4.
repeatedly until the factory setting
value š:‹‹ appears in the display
window h.
By pressing the 3 button you can
5.
switch intensive drying on š:‹‚ or
off š:‹‹.
Press START button `.
6.
The set value is saved.
31
Advertisement
Table of Contents
