Table of Contents
Advertisement
a
For Your Information
7
Maintenance
Cleaning the lens
If the lens becomes dirty, it may cause a skipping of sound
during CD operation. Clean with a commercially available
blower.
Cleaning the tape heads and tape path
Contaminated heads cause poor recording or sound drop-
out in playback. We recommend cleaning after every 10
hours of operation. To make the best possible recording,
however, you should clean all surfaces over which tape
travels before each recording.
Wipe the heads, the pinch rollers and the capstans with a
cleaning swab slightly moistened with cleaning fluid or
alcohol.
Playback head
Capstan
Pinch roller
Erase head
Record/
Capstan
playback
head
Pinch roller
After cleaning the heads, rollers and the tape path, insert a
tape when the areas cleaned are completely dry.
Demagnetizing the tape heads
After 20 to 30 hours of use, enough residual magnetism
will have built up on the heads to begin to cause loss of
high frequency sound and hiss. At this time, you should
demagnetize the heads and all metal parts in the tape path
with a commercially available tape head demagnetizer.
Cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth
slightly moistened with a mild detergent solution. Do not
use any type of abrasive pad, scouring powder or solvent,
such as alcohol or benzene.
14| For Your information
Notes on Compact Discs
¢ Before playing, clean the CD with a cleaning cloth. Wipe
the CD from the center out.
* Do not use solvents such as benzene, thinner,
commercially available cleaners or anti-static spray
intended for viny] LPs.
¢ Do not expose the CD to direct sunlight or heat sources
such as hot air ducts, nor leave it in a car parked in direct
sunlight as there can be a considerable rise in temperature
inside the car.
¢ After playing, store the CD in its case.
If there is a scratch, dirt or fingerprints on the CD, it may
cause tracking error.
Advertisement
Table of Contents
