Panasonic TC-26LX50 Operating Instructions Manual page 7

Receiver Location
Locate at a comfortaMe distance for viewing. Avoid pHacing where sunlight or other bright Hight(incHuding
reflections) wHH fan on the screen.
Use of some types of fHuorescent Hghting can reduce remote controHtransmitter range.
Adequate ventilation is essentiaH to prevent internaH component failure. Keep away from areas of excessive
heat or moisture.
Now to use the LOD stand
Adjust the stand to your desired angHe. The stand angHecan be rotated 20 o to the right / Heft.
Cabte cover Removal and Reinstaltation
Removal
Note:
20 0 °
1. Push down hooks and pull the
cover slightly towards yourself to
disengage the claws (at 3 points).
2. Slowly pull out in the downward
direction.
1. Insert the claws (at 3 points) at
the bottom.
2. Push the cover until hooks click
into place.
To avoid interference appearing on the screen, do not bundle the RF cable and AC cord to,
Opening Front Controt Door
Optiona! ExternaJ Equipment
ether,
!
Raise the lower part of the
door labeled "PULL".
The Video / Audio connection between components can be made with shielded video and audio cables. For
best performance, antenna cables should utilize 75 ohm coaxial shielded wire. Cables are available from
your dealer or electronic supply store.
Before you purchase any cables, be sure you know what type of output and input connectors your various
components require. Also determine the length of cable you'll need.
For optimum quality picture
When the LCD is exposed to light from outdoors or lighting fixtures, high-contrast pictures may not be displayed
clearly. Turn off florescent lamps near the LCD and place in a location not exposed to outdoor light.
Now to hang the LCD Television on the wan
This LCD Television is for use only with the following optional accessory. Use with any other type of optional
accessories may cause instability which could result in the possibility of injury.
• Wall-hanging bracket ........................................................ TY-WK32LX20W
Always be sure to ask a
qualified technician to carry
out set-up.
7