Honda PIONEER SXS500M 2020 Owner's Manual page 132

Changing Oil
Refer to Safety Precautions on page 91.
Change the oil with the front final gear at normal operating
temperature to assure complete and rapid draining.
1. Park the Honda SXS on a firm, level surface.
2. Place an oil drain pan under the oil drain plug.
3. Remove the oil filler cap and the drain plug.
4. After the oil has completely drained (3 – 5 minutes), reinstall the drain
plug with a new sealing washer and tighten it to the specified torque:
9 lbf·ft (12 N·m, 1.2 kgf·m)
5. Fill the front final gear with the recommended oil.
17.2 US oz (510 cm
6. Make sure the oil level is at the lower edge of the oil filler
inspection hole.
7. Apply a thin coat of grease to a new O-ring, and insert it into the
oil filler cap groove.
8. Install and tighten oil filler cap to the specified torque:
9 lbf·ft (12 N·m, 1.2 kgf·m)
9. Pour the drained oil into a suitable container and dispose of it in
an approved manner (page 188).
NOTICE
Improper disposal of drained fluids is harmful to the environment.
LEFT FRONT
Front Final Gear Oil
)
3
O-ring
lower edge of oil filler
inspection hole
oil filler cap
oil drain plug
sealing washer
Servicing Your Honda 125