Table of Contents
Advertisement
Installing monitor
1. Remove the monitor bracket and base from the packaging and place it on a stable and level
workspace.
2.
The display support is aligned with the corresponding slot of the base, rmly installed on the base;
Align the rotating shaft above the support with the corresponding slot below the monitor and install
it rmly on the monitor.
3. Support wall hanging function, VESA100*100mm, M4*10 screws.
Power saving
The monitor will be switched to "power saving" mode by the control signal from the display
controller, as indicated by the orange-colored power LED.
Power saving
The power saving mode will be kept until a control signal has been detected or the keyboard or
mouse is activated. The recovery time from "power saving" mode back to "on" is around 3 seconds.
Display Data Channel (DDC)
To make installation easier, so long as your system supports the DDC protocol, the monitor is able
to plug-and-play. The DDC is a communication protocol through which the monitor automatically
informs the host system about its capabilities; for example, supported resolutions and corresponding
timing. The monitor supports the DDC2B standard.
(As shown below)
Model
On
LED light
Green
Orange
2
Advertisement
Table of Contents
