Icom A25C Quick Operation Manual

• DIAGRAM
1
1. Omni Bearing Selector
3
(OBS) to select course
heading.
2. To / From Selector to invert OBS setting on
CDI screen.
3. Waypoint Navigation Key to display Waypoint Screen.
4. Direct To Key to display Direct To WPT screen for
Waypoint entry.
5. Flight Plan Key to display current flight plan.
• FLYING TO A VOR STATION*
Select a VOR Station's frequency.
- CDI screen is displayed.
Next, push , then"OBS" to
enter the OBS mode.
- OBS is highlighted and the
Course Deviation is displayed.
Next, push [ENT ANL], then
confirm the "TO / FROM"
indicator shows "TO". If "FROM"
is displayed, push , then push
"TO / FROM" to show "TO".
- Maintain the heading so that the
Course Deviation Needle comes
to the center of the CDI.
• SELECTING A WAYPOINT FROM
2
MEMORY OR FLIGHT PLAN
4
5 To select a waypoint from the
Memory push , then push
[5 ] for "Direct to WPT" screen.
Choose "Select Memory",then push
[ENT ANL ].
("GROUP LIST" SCREEN DISPLAYS)
Select a Group, then push [ENT
("COURSE TO" SCREEN DISPLAYS)
Enter the course, then push [ENT
("WAYPOINT NAVIATION" SCREEN DISPLAYS)
To select a waypoint from a flight plan, push
, then push [5
] for "Direct to WPT".
Select "Flight Plan", then push [ENT
Select a flight plan, then push [ENT
Select a waypoint, then push [ENT
Enter the course, then push [ENT
("WAYPOINT NAVIGATION" SCREEN DISPLAYS)
*See full manual for complete information about VOR.
**The course entry is required only when the CDI type
Navagation screen is selected.
©2021 Icom America Inc. The Icom logo is a registered trademark of Icom Inc. 43026
EMERGENCY
In case of emergency, you can immediately
select the 121.5 MHz emergency frequency.
].
ANL
• Push
the emergency frequency.
].
ANL
Push [CLR
previously selected frequency.
GENERAL
].
ANL If the button marking on the keypad is white,
].
ANL
push to activate. For secondary functions push
].
ANL
, then the desired orange-marked button.
].**
ANL KEYPAD
• POWER, ON or OFF
Push POWER KEY
second to turn the transceiver ON or OFF.
• SET SQUELCH
Push [SQLY] or [SQLZ]
to adust until the noise disappears.
when no signal is received.
QUICK
OPERATION GUIDE
a25C/a25n
, then push [7 ] to select
121.5
] to return to the
DEL
. Hold down for 1