Advertisement
PANEL FACILITIES
© DIRECT switch/indicator
Use this switch/indicator when you do not wish to pass the
output from input terminal equipment through the various
frequency adjusting circuits (SUBSONIC,
BASS, TREBLE,
BALANCE,
LOUDNESS)
and adaptor terminals (ADPT}.
ON:
The indicator lights: The signals input through the input
terminals
are
reproduced
without
passing
through
the
various frequency adjusting circuits. This results in flat, pure
sound which is a more faithful reproduction of the input
source.
OFF:
The
indicator goes
out: The signal passes
through the
various frequency adjusting circuits.
@ LOUDNESS switch/indicator
Use when listening at low volume levels.
ON:
The indicator lights: Boosts low and high frequencies to give
added punch to playback even at low volume levels.
OFF:
The indicator goes
off: Should
normally
be left in this
position.
NOTE:
This switch does not operate when the DIRECT switch is in the
ON position.
®@ SUBSONIC filter switch/indicator (Model A-443
only)
Use this switch when playing records with coarse grooves.
OFF;
Released position; leave in this position for normal playback,
ON:
Depressed position (the indicator lights). Jn this position,
frequencies of 17 Hz and below are cut, eliminating super-
low-frequency noise caused by coarse record grooves, and
thus helping prevent sound distortion.
NOTE:
This switch does not operate when the DIRECT switch is in the
ON position.
@ BALANCE control
Should normally be left in the center position. Adjust the
balance if the sound is louder from one of the speakers. if
the right side is louder, turn toward the Lileft) position and
if the left side is louder, turn toward the Riright) position.
NOTE: ©
This contro! does not operate when the DIRECT
switch is in the
ON position.
@
TREBLE tone control
Use to adjust the high-frequency tone. The center position
is the flat (normal) position. When turned to the right, high-
frequency tones are emphasized; when turned to the left,
high-frequency tones are de-emphasized.
NOTE:
°
This control does not operate when the DIRECT switch is in the
ON position.
e
At volume levels lower than ''4", the set tone control effect
is obtained.
At
volume
levels
higher
than
"4",
the
effect
becomes
increasingly weaker.
@ BASS tone control
Use to adjust the low-frequency tone. The center position
is the flat (normal) position. When turned to the right, low-
frequency tones are emphasized; when turned to the left,
low-frequency tones are de-emphasized.
NOTE:
®
This control does not operate when the DIRECT switch is in the
ON position.
e
At volume levels lower than ''4"', the set tone control effect
is obtained.
At
volume
levels
higher
than
"4",
the
effect
becomes
increasingly weaker.
@ PHONES jack
When using headphones,
insert the plug into this jack.
[REAR PANEL]
PHONO terminals.
LINE terminais.
ADAPTOR
OUT terminalis.
ADAPTOR
IN terminals.
DAT/TAPE
1 REC terminals.
DAT/TAPE
1 PLAY terminals.
SPEAKERS B terminals (right channel).
SPEAKERS B terminals (left channel).
Power cord.
Connect this cord to an AC wall socket, or the AC outlet
of an audio timer.
888860680
7
<ARB1102>
Advertisement
