Terminal Setup With The Feature Key - NEC DT510 User Manual

Terminal Setup With the Feature
Key
Microphone On/Off
LED on Mic key shows the status of the built-in
microphone.
(1) Press Mic.
To Select Ringer Tone
(1) Press Speaker and dial 720.
(2) Dial 1 to set Intercom ring; Dial 2 to set Trunk
ring.
SET INCOM RING
1: INT 2: EXT
(3) Dial code for the desired ring pattern (1~8).
Display below shows when INT is selected.
SET INT INCOM RING
INCOM RING 1-8:?
(4) Press Speaker to hang up.
Listening to the Incoming Ring Choices
(1) Press Speaker and dial 711.
(2) Dial 1 to listen to Intercom ring; Dial 2 to listen to
Trunk ring.
(3) For Intercom Ring:
Dial the code for the ring pattern you want to hear
(1-8).
Tone No.
1
2
3
4
5
6
7
8
-OR-
For Trunk Ring:
Dial code for the ring pattern you want to hear
(Ring1-3, Melody 4-8). If you select Ring 1-3, a second
screen prompts for the tone pattern (1-4).
Tone No.
1
2
3
4
5
6
7
8
6
Tone Range
High
Mid Range
Low
Ring Tone 1
Ring Tone 2
Ring Tone 3
Ring Tone 4
Ring Tone 5
Tone Range
Ring Tone 1
Ring Tone 2
Ring Tone 3
Melody 4
Melody 5
Melody 6
Melody 7
Melody 8