Garland SIOUX 855 ZESG Instruction Manual page 47

Follow step one and two of 6.3.2.1. COLD ENGINE
START if it is the first start. If the engine is hot, you
only need to follow step two.
Then press the E-starting button lightly, the engine
will start.
6.4. ENGINE STOP
Shut off the engine by releasing the safety switch bar.
6.5. TRACTION DRIVE
Press the traction bar against the handlebar as shown
in the figure, and the mower drive will come into
operation.
6.6. CHECKPOINTS AFTER STARTING THE MACHINE
It is important to pay attention to the possible
individual parts or and the temperature of the
machine. If you detect any anomaly in the machine
immediately stop and check it carefully.
In case of any malfunction or problem take the
machine to a service technician to be repaired.
Under no circumstances must you continue to use the
machine if the operation does not seem appropriate.
Do not use the machine if it is damaged or improperly
adjusted.
7. USING THE MACHINE
Use this machine only for the designated
purposes. Using this chainsaw for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
Do not start the machine in a room or
enclosure. The exhaust gases and fuel and
oil vapors contain carbon monoxide and
harmful chemicals. In case of a concentration of gases
produced by poor ventilation, remove all that impedes
the flow of clean air to improve ventilation from the
work area and not return to work in the area unless
you have properly ventilated area and have clear that
47/172
English