Advertisement

Quick Links

Register your product and get support at
www.philips.com/welcome
DS6200/93
User manual

Advertisement

Table of Contents
loading

Summary of Contents for Philips DS6200/93

  • Page 1 Register your product and get support at www.philips.com/welcome DS6200/93 User manual...
  • Page 2: Table Of Contents

    Contents 1 Important Important Safety Instructions 2 Your Docking Entertainment System Introduction What's in the box Overview of the speakers 3 Get started Connect speakers Connect power Turn on 4 Play Play from iPod/iPhone Play from an external device 5 Other features Synchronize the iPod/iPhone with a PC 6 Product information Specifications...
  • Page 3: Important

    1 Important Important Safety Instructions • Heed all warnings. Know these safety symbols • Follow all instructions. • Do not use this apparatus near water. • Clean only with dry cloth. • Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
  • Page 4: Your Docking Entertainment System

    Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the a DOCK bottom of the apparatus.
  • Page 5: Get Started

    3 Get started Connect power Caution Caution • Risk of product damage! Ensure that the power supply • voltage corresponds to the voltage printed on the Use of controls or adjustments or performance of bottom of the unit. procedures other than herein may result in hazardous •...
  • Page 6: Turn On

    4 Play Turn on In standby mode, there are two ways to turn on the unit. • Audio signal detected from the 30-pin Play from iPod/iPhone connector or from the AUX-IN port . » The ring tone is also recognized as audio signal.
  • Page 7: Play From An External Device

    Charge the iPod/iPhone Play from an external device with MP3 link cable When the unit is connected to power, the docked iPod/iPhone begins to charge Connect MP3 link cable to: automatically. • the AUX-IN socket on the back of the active speaker.
  • Page 8: Other Features

    5 Other features 6 Product information Synchronize the iPod/iPhone Note with a PC • Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 2 x 10 W RMS Frequency Response 60-20000 Hz, ±3dB Signal to Noise Ratio >...
  • Page 9: Troubleshooting

    If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www. philips.com/welcome). When you contact Your product is designed and manufactured Philips, ensure that the apparatus is nearby...
  • Page 10 The making of unauthorized copies of copy- protected material, including computer programs, files, broadcasts and sound recordings, may be an infringement of copyrights and constitute a criminal offence. This equipment should not be used for such purposes. “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod or iPhone respectively, and has been certified by the developer to meet Apple performance...
  • Page 11 Specifications are subject to change without notice © 2012 Koninklijke Philips Electronics N.V. All rights reserved. DS6200_93_UM_V1.0...

Table of Contents