Onkyo TX-8511 Instruction Manual page 25

Connection for Multi-Room Remote Control
The following instructions apply to other than U.S. or Canada model
Do noi plug in the power cord until all connections have been made. When making connections (?) through be sure to connect
the units as shown in the connection diagram below. Do not make a niLstake when connecting the units.
A. Connecting components equipped with OnkyoRl jacks
Components mounted in a rack should be connected as shown below to enable remote control operation.
1. Set up the cumponeiiLs (a) di.splaying
Onkyo's RI jack.
2. Ciinnect the sub room speaker
cables to the speaker U terminal on
lheTX-8511.(©)
install Remote Xensor IIR-IO in the
sub-room, then connect it to the
TX-8511. ((D)
B. Connecting components not equippped with OnkyoRl jacks
3. Remote Emtller
HE-SO(AC)
MAIN ROOM
Power.
supply^
4 Componenls(c)
SUB ROOM
Speaker A
(Mein room)
\rr
:—zx Remote sensor
Remote control HR-10-'v
Speaker B
, (Sub room)
Speoker B
(Sub room)
1. Connect (he components (b) to the
TX-8511.
2. Make the connections descrilted above
in steps 2 Ihruugli 3 or.section A.
3. Install Remote Emitter llE-50 (AC)
so that its sensor is directed toward
these components, (lien eonneet it to
the TX-8511. ((D)
(Cinmeel the AC adapter to the
Remote Emitter.)
■ Operating components which are
positioned out of the range of the
emitter installed as described
above.
4. Connect the components (c) to the
TX-8511.
5. Install Remote Emitter Head IlE-IO
so tliat its sensor is directed toward
these eomponenis. then connect it to
theHE-50(AC).(@)
Connection diagram