Kenwood DP-R893 Instruction Manual page 18

In case of difficulty
No power is applied with the POWER | e Power plug is loosely connected.
switch ON.
@ With the power plug connected to the
switched AC outlet of an amplifier, the
power of the amplifier is turned off.
Disc is loaded, player does not play. Disc is loaded upside down.
Disc is loose.
Disc is dirty.
Disc is cracked.
Condensation occured on the optical lens
unit.
Disc is not loaded.
Play mode is not entered (The play/pause
indicator is not lit).
Disc is too dirty.
Disc is cracked,
The connection cords are inserted loosely.
Music is interrupted. (Sound is skipped.) Disc is too dirty.
Dise is cracked,
Oscillation is applied to this unit.
Disc begins to play when power is The CD player will automatically play when
switched ON. a disc has been inserted and power is
switched ON.
Notes:
@ Insert the power plug firmly to the AC
outlet.
@ Turn the amplifier's power ON.
@ Load the disc again with its label side up.
@ Insert disc properly.
@ Wipe off the dust on the surface of the disc
referring to "Disc handling precautions".
@ Replace the disc with a new one.
@ Leave the player for about 1 hour so that
the condensation is removed.
® Loada disc and press the PLAY/PAUSE key
:
@ Press the PLAY/PAUSE key :
e@ Wipe off the dust on the disc surface
referring to "Disc handling precautions".
@ Replace the disc with a new one.
@ Connect all connection cords firmly.
@ Wipe off the dust on the disc surface
referring to "Disc handling precautions".
e@ Repiace the disc with a new one.
@ Try selecting a place where no strong vi-
brations occur by changing the installation
place, etc.
@ Toavoid disc playing automatically, remove
disc before switching off power.
cord, plug it and turn power on again.
the plastic components.
18 op-Re93 (En)