Table of Contents
Advertisement
Adjusting the Projector Function ("PRJ - ADJ" Menu)
(Continued)
6 Monitor Output
7 Audio Input
6
6
6
6
7
7
7
7
This function allows you to select an appropri-
ate combination of audio input terminals for each
input mode.
Selectable
items
The AUDIO 1 input terminal is used as
Audio 1
an audio input terminal.
Audio 2
The AUDIO 2 input terminal is used as
an audio input terminal.
8 Selecting the Transmission
8
8
8
8
Speed (RS-232C)
Make sure that both the projector and computer
are set for the same baud rate.
Selectable
items
Transmission speed is slow.
9600bps
115200bps
Transmission speed is rapid.
9 Fan Mode Setting
9
9
9
9
This function changes the fan rotation speed.
Selectable
items
Suitable for normal environments.
Normal
Select this when using the projector at
High
altitudes of approximately 1,500
meters or more.
When "Fan Mode" is set to "High", the fan rotation
speeds up, and the fan noise becomes louder.
0 System Lock Function
0
0
0
0
This function prevents unauthorized use of the
projector. Once this function is activated, users
must enter the correct keycode each time the
projector is turned on. We suggest you record
the keycode in a safe place where only au-
thorized users have access.
• If you lose or forget your keycode, contact
your nearest Sharp Authorized Projector
Dealer or Service Center (see page 66). Even
if the product warranty is valid, the keycode
reset will incur a charge.
46
Description
Description
P
R
Description
Menu operation n Page
a Setting/Changing the keycode
1
Select "System Lock", then press
ENTER or Q.
2
Select "Next", then press ENTER.
• The screen for entering the keycode
appears.
3
Press the 4 buttons on the remote
control or on the projector to enter
the preset keycode in "Old Code".
• When setting the keycode for the first time,
press R on the projector for four times.
• If you input a wrong keycode, the cursor
returns to the first point of the "Old Code".
• The preset keycode is 4 R buttons on
the projector. When you press the R but-
ton four times, the keycord input screen
disappears.
4
Press the 4 buttons on the remote
control or on the projector to enter
the new keycode in "New Code".
• You cannot use the following buttons for
keycode: STANDBY/ON, ON, STANDBY,
ENTER, L-CLICK, R-CLICK/RETURN
and MENU/HELP
• System lock function recognizes each
button on the remote control or on the
projector as an individual button, even if
they share the same button name. If you
used the buttons on the projector in set-
ting your keycode, the keycode cannot be
canceled with the remote control.
38
Advertisement
Table of Contents
Troubleshooting
