Introduction; About This Manual; Model Identification - Onan Performer Series Operator's Manual

Introduction
ABOUT THIS MANUAL
This manual covers the operation and maintenance
of the horizontal-shaft Performer Series of engines.
Each operator of the power equipment should study
this engine manual carefully and observe all of its
instructions and precautions. Proper use and peri¬
odic maintenance are responsibilities of the opera¬
tors) and are essential for top performance.
MODEL IDENTIFICATION
Whenever contacting an Onan dealer or distributor
for information, parts or service, always provide the
model number and the serial number marked on the
nameplate of the engine. (The serial number is in
the row marked "S/N", just below the model num¬
ber.) Figure 1 illustrates atypical engine nameplate
and Figure 2 the location of the nameplate on the
engine.
Genuine Onan replacement parts obtained from an
Onan dealer or distributor are recommended.
□[warning I Improper service or parts replace¬
ment can lead to severe personal injury or death
and to damage to equipment and property. Ser¬
vice personnel must be qualified to perform
electrical and mechanical service.
IMPORTANT ENGINE INFORMATION
ONAN CORPORATION
1400 73rd Ave. NE
Minneapolis, MN 5543
made in
u.s.
Engine Model:
P224G-S/1264F
S/N: L951234567
REFER TO OPERATOR'S MANUAL FOR
MAINTENANCE SPECIFICATIONS
AND ADJUSTMENTS.
THIS ENGINE MEETS 1995 -1998
CALIFORNIA EMIS REGULATIONS
FOR ULGE ENGINES
SN5980U1G2RA
UNLEADED GASOLINE ONLY
FIGURE 1. TYPICAL ENGINE NAMEPLATE
IAwarning] Unauthorized modifications or re¬
placement of fuel, exhaust, air intake or speed
control system components that affect engine
emissions are prohibited by law in the State of
California.
IAwarning! LPG (liquified petroleum gas) is
flammable and explosive and can cause as¬
phyxiation. NFPA 58 , Section 1.6 requires all
persons handling LPG to be trained in proper
handling and operating procedures.