Front Panel Facilities - Pioneer CT-F850 Service Manual
Hide thumbs
Also See for CT-F850:
- Service manual (48 pages) ,
- Operating instructions manual (18 pages)
Table of Contents
Advertisement
2. FRONT
PANEL
FACILIES
Cassette compartment illumination
Pe
ens
fp
neenfemnn
|
SENOUST COM
CLOSED LGOP DUAL CaPSTAN
2-MOTOR Tap
(POWER SWITCH
@ DUST COVER
(@ REMAINING TAPE MARKER
@TAPE COUNTER
This indicates the position of the tape run.
(5) TAPE COUNTER RESET BUTTON
Depress this button to reset the tape counter display to "000."
(MONITOR SWITCH
This switch is used to:select the output signals including those of
the headphones. The level meter display is also selected simulta-
neously and so when adjusting the recording level, be sure to set
this switch to SOURCE (depressed position).
For recording:
If you depress this switch to SOURCE, you will
be able to listen to the signals (recording input)
just before they are recorded. If you then release
to switch
to TAPE,
you
will be able to hear
the
signals
immediately
after
they
have
been
recorded (playback sound).
Select
this
switch
while
you
are
recording
(alternately
between
TAPE
and
SOU RCE) and
monitor the recording.
Release the switch to TAPE. You will not be able
to listen to the playback sound if the switch is set
to SOURCE.
For playback:
©® © © ®
@
@METER
SELECTOR SWITCH
PEAK:
When this switch is depressed to PEAK, the meter
functions as a peak meter.
AVERAGE:
When
the switch
is released
to AVERAGE,
the
meter functions as an ordinary level meter.
(DOLBY NR SWITCH
Set this switch to ON for recording with the built-in Dolby noise
reduction
system
and for the playback of tapes which have been
recorded using the Dolby NR system.
@TAPE SELECTOR
This selector
allows
the bias and equalizer characteristics to be
selected during recording and the equalizer characteristics during
playback in line with the type of tape you are using.
METAL:
For using metal tapes
STD:
For using ordinary or LH tapes
CcrO
:
For using chrome tapes
Fe-Cr:
For using ferrichrome tapes
(BIAS CONTROL
Use
this
control
to
adjust
the
bias
in accordance
with
the
characteristics of the tape being used. It is set so that the center
(click stop) position corresponds to the standard bias.
Advertisement
Table of Contents
