Pu Operation Mode (Operation Using The Control Panel) - Mitsubishi Electric FR-E540-0.4K-EC Instruction Manual

3.3.3 PU operation mode (Operation using the control panel)

(1) Using the control panel (FR-PA02-
frequency setting
Operation command:
Frequency setting:
Related parameters: Pr. 79 "operation mode selection"
By repeating step 2 below during motor run, speed can be varied.
Step
Power on → Operation mode check
Switch power on, refer to page 52, and set "1" in Pr. 79
"operation mode selection".
1
The [PU] indication is lit.
Running frequency setting
Set the running frequency to 50Hz.
1) Refer to page 51 and select the frequency setting mode
2
with the
MODE
2) Refer to page 52, change the setting with the
key, and write the new setting with the
Start
Press the
RUN
mode is automatically selected and the output frequency is
3
displayed.
The [RUN] indication is lit to indicate forward rotation, or
flickers to indicate reverse rotation.
Stop
STOP
Press the
RESET
The motor is decelerated to a stop.
4
The [RUN] indication goes off.
(2) PU jog operation
Hold down the (or
RUN
1) Set Pr. 15 "jog frequency" and Pr. 16 "jog acceleration/deceleration time".
2) Select the PU jog operation mode. (Refer to page 54.)
3) Hold down the
RUN
(If the motor remains stopped, check Pr. 13 "starting frequency". The motor will not
start if its setting is lower than the starting frequency.
key or control panel (FR-PA02-
RUN
/ key
Description
key.
key (or / key). The monitoring
FWD REV
key.
or ) key to perform operation, and release it to stop.
FWD REV
(or or ) key to perform operation.
FWD REV
) for operation at 50Hz with digital
02
) /
02
FWD REV
/
key.
SET
58
key
Image
ON
PU
(or)
Hz RUN
A MON
PU EXT
MODE SET REV
STOP
FWD
RESET
RUN
REV
FWD
Hz RUN
A MON
PU EXT
MODE SET REV
STOP
FWD
RESET
Hz RUN
A MON
PU EXT
3