Philips 39PFL4756/F8 User Manual page 3

Important safety instructions
1.
Read these instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Do not use this apparatus near water.
6.
Clean only with dry cloth.
7.
Do not block any ventilation openings. Install in
accordance with the manufacturer's instructions.
8.
Do not install near any heat sources such as
radiators, heat registers, stoves, or other apparatus
(including ampli ers) that produce heat.
9.
Protect the power cord from being walked on or
pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the apparatus.
10.
Only use attachments / accessories speci ed by
the manufacturer.
11.
Use only with the cart, stand,
tripod, bracket, or table speci ed
by the manufacturer, or sold with
the apparatus. When a cart is used,
use caution when moving the cart /
apparatus combination to avoid
injury from tip-over.
12.
Unplug this apparatus during lightning storms or
when unused for long periods of time.
Wall mount bracket kit
Model
39PFL4756/F8
Your TV meets the VESA standard for wall mounting. Consult with
●
your local dealer for a wall mount bracket which is compatible with
your TV model.
The recommended wall mount bracket kit (sold separately) allows
●
the mounting of the TV on the wall.
For detailed information on installing the wall mount, refer to the
●
wall mount Instruction book.
P&F Mexicana S.A. de C.V. is not responsible for any damage to the
●
product or injury to yourself or others if you elect to install the TV wall
mount bracket or mount the TV onto the bracket on your own.
The wall mount bracket must be installed by experts.
●
Screw dimension
Upper: M6 x 16mm
Bottom: M6 x 10mm
13.
Refer all servicing to quali ed service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
Note to the CATV system installer:
This reminder is provided to call the CATV system
installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be
connected to the grounding system of the building, as
close to the point of cable entry as practical.
Example of antenna grounding as per NEC -
National Electric Code
GROUND CLAMP
ELECTRIC SERVICE EQUIPMENT
P&F Mexicana S.A. de C.V. is not liable for these types of acci-
dents or injuries noted below.
Install the wall mount bracket on a sturdy vertical wall.
●
If installed onto a ceiling or slanted wall, the TV and wall mount
●
bracket may fall which could result in a severe injury.
Do not use screws that are longer or shorter than their speci� ed
●
length. If screws too long are used this may cause mechanical or
electrical damage inside the TV set. If screws too short are used this
may cause the TV set to fall.
Do not fasten the screws by excessive force. This may damage the
●
product or cause the product to fall, leading to an injury.
For safety reasons use 2 people to mount the TV onto a wall
●
mounting bracket.
Do not mount the TV onto the wall mounting bracket while your
●
TV is plugged in or turned on. It may result in an electrical shock
injury.
When installing the unit on the wall, allow this much space.
Top : 1 1.8 " (30 cm)
Left and right side : 5.9 " (15 cm)
Bottom : 3.9 " (10 cm)
ANTENNA LEAD IN WIRE
ANTENNA DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM (NEC ART 250,
PART H)