Advertisement
4.5.2. Command Set
No.
Adjust mode
CMD(hex)
1
EEPROM WRITE
A0h
* Description
FOS Default write : <7mode data> write
Vtotal, V_Frequency, Sync_Polarity, Htotal, Hstart, Vstart, 0,
Phase
Data write: Model name and Serial number write in EEPROM,.
4.5.3. Method & notice
A. Serial number D/L is using of scan equipment.
B. Setting of scan equipment operated by Manufacturing
Technology Group.
C. Serial number D/L must be conformed when it is produced
in production line, because serial number D/L is mandatory
by D-book 4.0.
* Manual Download (Model Name and Serial Number)
If the TV set is downloaded by OTA or Service man, sometimes
model name or serial number is initialized.(Not always)
There is impossible to download by bar code scan, so It need
Manual download.
1) Press the 'Instart' key of Adjustment remote control.
2) Go to the menu '6.Model Number D/L' like below photo.
3) Input the Factory model name(ex 32LV2510-TB) or Serial
number like photo.
4) Check the model name Instart menu. -> Factory name
displayed. (ex 32LV2510-TB)
5) Check the Diagnostics. (DTV country only) -> Buyer model
displayed. (ex 32LV2510)
4.5.4. Outgoing condition Configuration
- When pressing IN-STOP key by Service remote control, Red
LED are blinked alternatively. And then automatically turn
off. (Must not AC power OFF during blinking)
4.6. Hi-pot test
Confirm whether is normal or not when between power
board's ac block and GND is impacted on 1.5 kV(dc) or 2.2
kV(dc) for one second.
Copyright ©2011 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LENGTH(hex)
Description
84h+n
n-bytes Write(n=1~16)
- 13 -
LGE Internal Use Only
Advertisement
