Video Recorder; Other Equipment; Side Connections; Amplifier - Philips 28PW8717 Handbook

Connections
Depending on the versions, the TV set is equipped with 2 or 3 SCART connectors EXT1, EXT2 and
EXT3 located on the rear.
The EXT1 connector has audio video inputs/outputs and RGB inputs.
The EXT2 connector has audio video inputs/outputs and S-VHS inputs.
The EXT3 connector has audio video inputs.

Video recorder

CABLE
VCR

Other equipment

CABLE

Side connections

Amplifier

AUDIO
12
Carry out the connections shown opposite, using the EXT2
connector. Use a good quality SCART connector cable.
If your video recorder does not have a SCART connector, the only possible
connection is via the aerial cable.You will therefore need to tune in your
video recorder's test signal and assign it programme number 0 (refer to
EXT 2
manual installation p.5).To reproduce the video recorder picture, press
Video recorder with Decoder
Connect the decoder to the second SCART connector of the
video recorder.You will then be able to record scrambled
transmissions. See also the
Satellite receiver, decoder, DVD, games, etc.
Carry out the connections shown opposite.To optimise
picture quality, connect the equipment which produces the
RGB signals (digital decoder, DVD players, games, etc...) to
EXT1, and the equipment which produces the S-VHS signals
(S-VHS and Hi-8 video recorders) to EXT2, ...). For digital
equipment or a decoder, go to the
(see next page).
To select connected equipment
Press
(decoder, video recorder) carries out this switching automatically.
Make the connections as shown opposite.With the key
select FRONT.
For a monophonic device, connect the audio signal to the AUDIO L
input. Use the
speakers of the TV set.
Headphones
The
settings, page 6).
The headphone impedance must be between 8 and 4000 ohms.
To connect to a Hi-fi equipment, use an audio connection
cable and connect the "L" and "R" outputs of the TV set to
the "AUDIO IN" "L" and "R" input of the Hi-fi equipment.
to select
EXT1
key to reproduce the sound on the left and right
keys are used to adjust the volume. Press the
key to mute the sound on the TV set (see also sound
menu (following page).
SETUP
menu settings
SETUP
or (or . Most equipment
EXT2 EXT3)
.
,