Table of Contents
Advertisement
@.... This TV. set is designed to operate on A.C, 220 — 240V,
TV. Games / Home Computers
Gori.
Extendéd use of TV games or homecomputers with any television
e .... Do not expose this TV set to rain or excessive moisture.
set can cause a permanent 'shadow' on the screen. This type of
¢ .... WARNING: HIGH VOLTAGE !
irreversible picture tube damage, can be limited by observing the
Do not remove the rear cover, there are no user
following points :
Do not pull the power cable to remove the mains plug
as such is not covered by the Panasonic warranty.
from the socket, always remove it by the plug.
e .... Before cleaning remove the mains plug from the wall
socket. The cabinet and picture tube can be cleaned
with a soft cloth moistened with mild detergent and
water. Do not use solutions containing benzol or
petroleum.
@ .... TV sets can produce static electricity, care must be taken
whenever touching the TV screen.
FOR YOUR SAFETY PLEASE READ THE FOLLOWING CAREFULLY
This appliance is supplied with a fitted three pin mains plug for your safety and convenience. A 5 amp fuse is fitted in this plug. !f the
fuse is replaced then the replacement fuse must be 5 amp rated and should be approved by ASTA or BSI to BS1362.
Check for the ASTA mark
or the BSI mark NY on the body of the fuse.
If the fitted plug has a removable fuse cover you must ensure that itis refitted when the fuse is replaced. If you lose the fuse cover the plug
must not be used until a replacement cover is obtained.
Replacement fuse covers can be purchased through your local Panasonic dealer.
if the fitted plug is unsuitable for the socket outlet in your home then the fuse should be
removed and the plug cut off and disposed of safely. There is danger of severe electrical
shock if the cut off piug is inserted into any 13 amp socket.
if a new plug is to be fitted please observe the wiring code as shown below.
If in any doubt please consult a qualified electrician.
How to replace the fuse :
Lift out the removable fuse compartment with a screwdriver and replace the fuse, then refit
securely into the mains plug.
IMPORTANT :—_The wires in the mains lead of this appliance are coloured in accordance with the following code :—
BLUE : NEUTRAL
BROWN : LIVE
As the colours of the wires in the mains lead of this appliance may not correspond to the markings identifying the terminals in your piug,
proceed as follows :—
1.
The BLUE wire must be connected to the terminal marked 'N' or coloured black.
2.
The BROWN wire must be connected to the terminal marked 'L' or coloured red.
IMPORTANT NOTE: Undernocircumstances should either ofthese wires be connectedto the Earth terminal ofthe three pin plug, marked
with the letter 'E' or the earth symbol ( —L ).
Advertisement
Table of Contents
