Table of Contents
Advertisement
_RECORDING
prem
ha
a
poe
|
"~3 dB" indicator lights steadily most of the time eres
will be
| RECORDING (Deck I only}
{
done #f the "0 dB™ indicator lights momentarily at peaks. When
recording without Dolby NA, set the REC LEVEL contral so that the
°-3 dB" indicator lights. and the "0 dB" indicator lights occasion-
ally at peaks.
NOTES:
©
The optimal recording level may differ somewhat depending an
the audio source and type of tape used. In order to obtain the
best possible results, set the recording level after actual Yesting.
listen to your recordings, and adjust the level as necessary.
@
The Jevel meter may react differently during recording and
playback of the same tape.
This is due to differences in tape
sensitivity, and creates no problem.
1, Load a tape for recording in Deck Il.
| RECORDING
MUTE
2. Set the DOLBY NR switch.
3. Set the REV MODE switch. (Except for CT-W203)
Use this function to create the 4.5-second blanks required for
©
To record on one side only, set the switch to the == posi-
proper operation of the music search function.
tion. To record on both sides, set the switch to either the =>
®
Press the recording mute (© ) button during recording and the
or the ex» position.
deck will create a blank space by recording a section which
4. Press the recording () button.
contains no signal for approximately four seconds, The deck
5. Prepare the audio source from which you wish to re-
will then enter recording standby mode.
® To create a blank which is more than four seconds long, hold
cord. Turn on the stereo amplifier and prepare it for
the button down for the desired length of time. When the but-
playback of the desired audio source.
7
és
:
6. Adjust the recording level. For details, see "ADJUST-
ton is released, the deck will enter recording standby mode.
ING THE RECORDING
LEVEL"
below.
©
To resume recording, press the pause (11) button or the play-
Press the playback (P or <) button or the pause (11)
back (Por <4) button.
button to begin recording.
@ When recording on both sides, press the ® button. If the ¢
ERASING
A TAPE
button is pressed, recording will stop after only one side is
reorded, {Except for CT-W203}
To erase the recorded contents of a tape, load the tape in DECK i!
and follow the procedure below.
é
To stop recording temporarily
Press the pause (18) button.
@ To resume recording, either press the pause ( tt) button again,
|
or press the playback (> or <) button.
i
To Stop Recording
ewe
|
Press the stop (lf) button.
So
Mead
i
{
SSOccepoa
Erasure prevention tabs
&
The recording (#} button does not work when the erasure preven-
The adjustment of the recording level is the most important factor
pate
in achieving good recording results. A high level provides a good
signal-to-noise ratio and dynamic range, but an excessively high
level distorts the sound. If the level is set too low for fear of sound
distortion, irritating tape hiss will mar the recording. The charac-
teristics of tapes differ depending on the manufacturer and the
type of tape. Set the REC LEVEL control so that the ievei meter's
ers
<RRB1142>
En
Hide quick links:
Advertisement
Table of Contents
