Advertisement
HOW TO LOAD THE CAMERA WITH FILM
The film: Use only Polaroid Polacolor Land film
packs, Type 108. Each pack makes eight pictures.
1.
Open the package: Siide the foil bag out of the
box. Handle it carefully and only by the edges. Tear
the bag along the dotted line and remove the pack.
A
2.
Unlock and open the back: Push up both ends
of the back lock (A) and open the back ail the way.
4.
Check the white tabs (C): Be sure that they are
not caught between the pack and the camera.
6.
Grip the black tab: Hold the camera by the
han die and get a grip on the black tab (0) as shown.
The black tab is the end of the safety cover. Pull
the safety cover ail the way out of the camera.
Pull it straight and be careful not to rip it.
Hold it only by the edges. Oiscard the moisture
absorbing card which is inside the foil bag with the
pack (some packs may not have a card). Save the
box and the foil bag for carrying prints and waste.
Please read the instruction sheet carefully so
you'II know how long to develop your pictures.
3
.
Insert the pack: Hold the film pack by the
edges as shown. Push the closed end of the pack
under the light shield (B) against a spring and then
push the pack down into the camera.
5.
Close and lock the back: Hold the back closed
and push down on the center of the lock (A). The
black tab on the safety cover (0) should stick out
behind the lock.
7.
Look for the white tab: When the safety cover
is removed, a white tab (E) should stick out of the
small slot next to the lock.
If you can see a white tab, you are now ready to
take picture No. 1.
If there is no white tab: Turn to page 23.
5
Advertisement
