Advertisement
Quick Links
The IPW-10VR is an analog-to-IP converter that uses 2-conductor copper wire to connect IP intercom stations. The converter comes
with a power supply and ten 2-wire to RJ-45 converters. Purchase an additional IPW-1VT adaptor for each intercom station.
Features
• Works with existing 2-conductor copper wire
• Provide PoE to door stations up to 1000 feet away
• Connects up to ten door stations with a single network port
• Rack mountable
• LED status indicators
Package Contents
PS-1225UL
IPW-10VR Rack Mount
Receiver Module
4 M5 Screws
If updating dimensions, be sure to update the GLC layer too.
Please refer to the Product Dimensions Master located here:
10 2-wire to RJ45
H:\Engineering Services\Product Dimensions Master Document\Product Dimensions Master.xlsx
converters
IPW-10VR
INSTALLATION GUIDE
3-9/16"
2-1/16"
Outlet Plug
Installation and Configuration
The IPW-10VR is configured out of the box to provide power
and network connection on all ten of the PoU (Power over
UTP wire) ports.
For each station connected to the IPW-10VC, use two of
the 2-wire to RJ45 converters. One will plug into a port
on the IPW-10VR, and the other will go into the IPW-1VT
transmitter module. Use a small Phillips-head screwdriver to
loosen and tighten the converters to connect the 2-conductor
wires to both sides.
The four provided screws allow the IPW-10VR receiver module
to be installed in a 1U server rack space.
The IPW-10VR is powered from a wall outlet, and is connected
to the network by one of the two ethernet ports.
06/23
1
Advertisement
Summary of Contents for Aiphone IPW-10VR
- Page 1 INSTALLATION GUIDE The IPW-10VR is an analog-to-IP converter that uses 2-conductor copper wire to connect IP intercom stations. The converter comes with a power supply and ten 2-wire to RJ-45 converters. Purchase an additional IPW-1VT adaptor for each intercom station.
-
Page 2: Poe Switch
Sample Wiring Diagram PoE Switch IX-MV7 Cat-5e/6 Cat-5e/6 IPW-10VR 2-Conductor 2-Conductor 2-Conductor Wire Wire Wire Wall Outlet IPW-1VT IPW-1VT IPW-1VT Transmitter Transmitter Transmitter Cat-5e/6 Cat-5e/6 Cat-5e/6 IX-DV IX-SS-2G IX-MV7 06/23... - Page 3 Web Interface Instructions The IPW-10VR features a web interface that can be used to adjust its network settings, change the log in credentials, restart, or factory reset the station. The network and security settings may not need to be adjusted on all sites, since the IPW-10VC kit can work on an isolated network. Consult on-site IT about networking requirements.
- Page 4 Changing the User Name and Password Navigate to System Configuration, User. Enter the desired login credentials and click Save Restarting the Station Navigate to Maintenance, Restart Device. Click Factory Resetting the Station Navigate to Maintenance, Factory Defaults. Enter the desired login credentials and click Save 06/23...
-
Page 5: Fcc Warning
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. For more details about the features and information above, please contact Technical Support. Aiphone Corporation | www.aiphone.com | (800) 692-0200...