Table of Contents
Advertisement
M
Setting the signal and
current
Y ou can change the following settings:
S e t t i n g t h e s i g n a l a n d c u r r e n t
The speed at which the washing
■
machine was spun; only used if the
anticipated drying time needs to be
displayed more accurately,
The volume of the audible signal at
■
the end of the programme,
The volume of the audible button
■
signals,
The current rating for your dryer's
■
fuse (10 A or 16 A).
The values for the energy
Note:
label are determined using a circuit
breaker/fuse rating of 16 A. If the
circuit breaker/fuse rating is
changed to 10 A, the drying time
and energy consumption will be
higher. You can find details on this in
the consumption values table.
~ Page 36
You must activate the setting mode in
order to change these settings.
Setting the signal and current
Activating setting mode
Switch the dryer on.
1.
Select the "Cottons" programme in
2.
position 1 and wait for five seconds.
Setting mode is now activated. The
symbols go out in the display panel and
the programme duration is displayed.
Press and hold the Start button and,
1.
at the same time, turn the
programme selector clockwise to
position 2.
The spin speed is shown in the
2.
display.
Press the "Ready in" time button or
3.
the drying time button to change the
spin speed.
Turn the programme selector
4.
clockwise to position 3.
The volume of the audible signal at
5.
the end of the programme is shown
in the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
Press the "Ready in" time button or
6.
the drying time button to change the
volume.
en
29
Advertisement
Table of Contents
