Table of Contents
Advertisement
The remote control unit provided with the receiver can also contro! KENWOOD cassette decks, and CD player connected to the -
receiver through system control cords. For details of the controllable functions, refer to the instruction manuals of these
components.
@ POWER
key
O@BAND key
Ga]
Press to switch the broadcast band,
©P.CALL keys
~(36)
Recalls preset stations.
©Play/pause key (»/11) (CD)
Stop key (m) (CD)
OSkip keys (<4 , >i} (CD)
7
@DISC SKIP key {CD}
For use as the disc skip key of the multi-CD player.
© Input selector keys
(70)
Press to select the inputs.
@LEVEL MODE key
~(iq)
Press when adjusting the tone.
@TAPE A/TAPE B keys (Cassette decks)
@Play keys (4, ») (Cassette decks}
@ Fast Forward/Rewind keys (<< , »») (Cassette decks)
@Stop key (m)} (Cassette decks}
@REC/ARM key (Cassette decks)
When recording on TAPE B, puts the deck in record-pause mode
after leaving a non-recorded blank of 4 seconds.
y
@MUTING key
—(i3)
KENWOOD
Press to mute sound temporarily.
\
—
}
@LOUDNESS key
(it)
Press to enhance low frequencies.
@®VOLUME/LEVEL CONTROL keys
—(70) ~(1)
Press to adjust the volume. if the LEVEL MODE
key is pressed
before these keys, these keys can also be used to adjust the
tone.
Model: RC-R0504
Infrared ray system
Loading batteries
(>Remove the cover.
Operation procedure
When the STANDBY indicator is lit, the power turns ON when
you press the POWER
key on the remote. When the power
:
comes ON, press the key you want to operate.
@: Insert batteries.
Approximate operating range
Remote sensor
@ Insert two AA-size (R6 / SUM-3} batteries as indicated by the
polarity marking.
Model: RC-RO504
Infrared ray system
) Close the cover.
e When
two
operation
keys on the remote
control
unit are
pressed successively, press each key securely reserving an
interval of more than 1 second for each press.
2. When the remote-controllable distance gets shorter than before, replace botH,batteries with new ones.
3 Malfunction may occur if direct sunlight or the light of a high-frequency lighting fluorescent lamp enters the remote control light
sensor. In such a case, change the system installation position to prevent the malfunction.
as
1. The supplied batteries are intended for use in operation checks. Therefore, their lives may be shorter than ordinary batteries.
ay.
Advertisement
Table of Contents
