Sony SLV-675HF Operating Instructions Manual page 6

Re |
Step 2:
Setting up the remote commander (continued)
Controlling other TVs with the remote commander
The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the table below, set the appropriate manufacturer's code
number.
1) Set TV|/[VTR' at the top of the remote commander to :TV |.
2 Hold down POWER, and enter your TV's code number(s) using the
number buttons. Then release POWER.
Now you can use the POWER, VOL +/-, CH +/- and TV/VTR buttons to
control your TV. You can also use the buttons marked with a dot (¢) to
control a Sony TV. To contrel the VCR, reset |TV |// VTR] to; VTR}.
Code numbers of controllable TVs
If more than one code number is listed, try entering them one at a time until
you find the one that works with your TV.
Manufacturer Code Manufacturer Code Manufacturer Code
number number number
Sony 01 — Ivo 7 09 aa RCA 04,10
Akai (isi: s:s*=<i«é'«KM' 03 Sampo 12
AOC : 04 : Magnavox 03,08,12 Sanyo aie 1 =
Centurion = 12,2" Marantz) =(04,13 Scott 12
Coronado 3 MGA/Mitsubishi 04,12,13,17 Sears 07,1011
Curis-Mathes 12 NEC 0412s Sharp,—————S—«(8,05,18
Dayton 12 Panasonic 06,19 = Sylvania 08,12
Emerson 03,04,14 Philco 03,04 Teknika 03,08,14
Fisher 11 Philips 08 Toshiba 07
General Electric 06,10 Pioneer 16 Wards 7 03,04,12
Gold Star 03,04,17 Portland 03 Yorx 12
Hitachi 02,03 Quasar 06,18 Zenith 15
J.C.Penny 04,12 Radio Shack 05,14
Notes
¢ If the TV uses a different remote control system from the one programmed to work
with the VCR, you cannot control your TV with the remote commander.
_ © If you enter a new code number, the code number previously entered will be erased.
¢ When you replace the batteries of the remote commander, the code number
automatically resets to 01 (Sony). Reset the appropriate code number.
Getting Started