Advertisement
FIGURE 19.
OPERATION
GAS AND OIL FILL-UP
Service the engine with gasoline and oil as instructed
in the separate engine manual packed with your tiller.
Read instructions carefully.
NOTE
Your tiller is shipped without oil; how¬
ever, a small amount of oil may be
present from the factory.
TO START ENGINE
Ac
WARNING*}
BE SURE NO ONE IS STANDING IN
FRONT OF THE TILLER WHILE THE
ENGINE IS RUNNING OR BEING
STARTED.
1. Attach spark plug wire to spark plug.
2. Move the throttle control lever forward to FAST
position. See figure 20.
23. Place the depth bar (V) in position on the tailpiece.
Secure with clevis pin (E) and hairpin cotter (F).
-See figure 19.
3. Move choke lever to CHOKE position. See figure
21. After the engine starts, gradually push the
choke lever off.
■^NOTE
A warm engine may not require
choking.
4. Stand at side of the tiller, grasp the starter handle
and pull out rapidly. Return it slowly to the engine.
Repeat if necessary.
FIGURE 21.
TO STOP ENGINE
Move throttle control lever to STOP position. See figure
20
.
TO ENGAGE TINES
To engage the tines, squeeze the clutch grip. To stop
the tines, release the clutch grip. See figure 20.
10
Advertisement
