Table of Contents
Advertisement
PRESET TUNING
[FREQUENCY PRESETTING |
Allows
three stations per STATION
CALL
button
(press once,
twice, or three times to select).
@-.
000
foaeot |
ssa2e ¢) © O] |
5
4
1. Press the POWER
switch to the ON position.
NOTE:
Be sure to turn the TAPE 2 MONITOR button OFF when listening
to AM or FM broadcasts.
2. Press the TUNER
button and Set the FM/AM
selector to either FM or AM.
3. Tune in the desired station.
* See the section 'DIRECT ACCESS TUNING?' for information on
reception using the Direct Access Tuning mode.
* See the section "MANUAL/AUTO
TUNING" for imformation
on reception using the manual tuning mode.
In addition
to station frequencies,
the MPX
MODE(AUTO/
MONO) can also be preset.
4. Press the MEMORY
button.
* The MEMORY indicator will flash.
5. press the STATION CALL button into which you
wish to preset the station.
* Press the STATION CALL button while the MEMORY indicator
is flashing (about 5 seconds}.
* Use the STATION
CALL buttons («1
~
*9, *O) to select a
preset channel. One press selects the 1 — 10 range, two press-
es 11
-
20, and three presses 21 ~
30.
[Example] If you press button |*3;
Once — STATION 3
Twice — STATION 13
Three times — STATION 23
Press a STATION CALL button within two seconds,
When the display stops flashing, the station is preset.
NOTE:
Do not press buttons while the display is still flashing.
6. Repeat steps 2 to 5 to preset additional stations.
A total of 30 AM and FM stations may be preset. When you store
anew preset, it takes the place of the previously stored station {if
any).
LISTENING
TO
BROADCASTS
USING
PRESET TUNING
1. Press the POWER switch to the ON position.
2. Press the STATION CALL button into which the
desired station has been preset.
¢ When the Function button is set to a function other than
TUNER, it will switch to the TUNER function automatically if
one of the STATION
CALL buttons is pressed.
Tuning can be performed simply and accurately following the
above procedure,
3. Adjust the volume with the VOLUME control and
the tone with TREBLE tone control, BASS tone,
control and S.BASS button.
NOTE:
The contents of the STATION CALL button will be preserved for
several days, even if the receiver power cord is unplugged.
If a preset station has been erased, preset it again.
Last station memory
The last received
AM
and FM stations remain
stored despite
FUNCTION and/or POWER switching. To recall, use BAND setec-
tor buttons,
Memory SCAN function
Press the MEMORY
SCAN button and preset broadcast stations
are recieved for several seconds in the order of their STATION
CALL numbers. Press again to stop.
<ARB1470>
Advertisement
Table of Contents
