Electrical Connection; Before You Begin; Tools And Parts Needed; Parts Included - Bosch HIB82651UC Installation Instructions Manual

Electrical connection
WARNING
RISK OF ELECTRIC SHOCK
Parts inside the appliance can have sharp edges.
The connection cable can be damaged. Do not
bend or pinch connection cables during installation.
Before connecting the appliance, check the household
installation. Ensure sufficient fuse protection of the
household installation. The voltage and frequency of the
appliance must match the electrical installation (see
rating plate).
The appliance complies with protection class 1 and must
only be operated in conjunction with a protective
conductor terminal.
An all-pole isolating switch with at least a 3 mm contact
gap must be fitted in the installation. This must remain
accessible after installation.
Only a qualified electrician who takes the appropriate
regulations into account may lay or replace the
connecting cable.
Follow all valid standards and laws.
Ensure that the electrical connection meets the
requirements of the latest version of all applicable
standards and laws in the appropriate country, especially
the following standards: National Electrical Code,
ANSI/NFPA 70", or CSA Standards C22.1-94, Canadian
Electrical Code, Part 1 and C22.2 No.0-M91**.
Have a qualified electrical technician check the
grounding of the appliance.
Do not ground with a gas line.
No fuse protection in the neutral or grounding circuit.
Keep the installation instructions. Only connect the
appliance with a copper conductor. If possible, connect
the appliance to a metal cable guide directly to the fuse
box.
Ensure that the wire diameter meets the requirements of
the latest version of all applicable standards and laws in
the appropriate country, especially the following
standards: National Electrical Code, ANSt/NFPA 70", or
CSA Standards C22.1-94, Canadian Electrical Code, Part
1 and C22.2 No.0-M91**.
Put a protecting hose that is listed in the U.L. or C.S.A. on
both ends of the connecting cable, that is, on the
appliance and on the fuse box.
For copies of the standards listed, contact:
* National Fire Protection Association Batterymarch Park
Quincy, Massachusetts 02269
** CSA International 8501 East Pleasant Valley Road
Cleveland, Ohio 44131-5575
Before You Begin
Tools and Parts Needed
o Measuring tape
o Pencil
o Phillips screwdriver (Posidrive) #2, Torx screwdriver
#10
o Drill with the following bits: 5/16" (7.9 mm) and 3/8"
(9.5 mm)
o Spirit-level
o Aluminum tape (DO NOT use insulating tape)
o Exhaust air duct (configuration depends on the
installation situation)
o Additional sheet metal screws (if necessary for
installation of the exhaust air duct)
Saw
Parts included
o Extractor hood with fan, back-pressure flap
÷ Lamp, already installed
o Metal grease filter
o Drill template
o Installation manual and instructions for use
o 4x screws, 5x45 mm
o 64x screws, 4x8 mm
o 6x screws, 3.5x9.5 mm
o 4 flue ducts with 4 plastic brackets.
o Torx adapter, 10