Technical Precautions; Specifications; Warranty - Aiphone JF-2SD Installation & Operation Manual

6-4 | Transfer entrance call
1 During communication with door station, press CALL button to call 3 If TALK button is pressed at the transferred station, communication
the transferring station. with door station is performed. Press TALK button to end
* CALL button (red) flashes and the communication with door communication.
station is put on hold.
* The "AII Call" function is activated to link all the master stations.
NOTES:
1. If TALK button is pressed at the transferring station before starting
2 If TALK button is pressed at the transferred station, the unit communication between the transferred station and door station, the unit
enters room-to-room communication. The sender informs the enters the condition where the forwarding source communicates with door
receiver that communication will be transferred, and TALK station. After ending the room-to-room communication in step 2, TALK button
button is pressed and released at either the transferring station or must not be pressed at the transferring station for a while (until the transferred
transferred station to end the room-to-room communication. station enters communication with door station).
2. Communication with door station ends automatically approx. 1 minute after
first starting the communication.
Press TALK button within 30 seconds to start it again.
[6-5 | If optional units are installed
1 When a sensor is activated or a call button is pressed, the 2 Press TALK button to stop the notification sound.
notification sound goes off and the entrance LED (red) and
transmit LED (red) flash.
NOTES:
1. The notification sound volume does not link with "Chime tone volume
control". It sounds at a volume equivalent to "High" (fixed).
2. The notification sound only goes off during the times set in the external
sensor input settings of the master monitor station (JF-2MED).
7. TECHNICAL PRECAUTIONS
* Operating temperature: 0 °C to 40 °C (+32 °F to +104 °F) * Cleaning: Clean the units with a soft cloth dampened with a neutral
household cleanser. Do not use any abrasive cleaner or cloth.
| § | SPECIFICATIONS
* Power: Supplied from the master monitor station
* Calling: Chime, approx. 45 seconds
* Communication: (HANDS-FREE mode) Approx. 60 seconds
(PTT mode) Press-to-talk, release to listen, approx. 60 seconds
* Dimensions: 160 (H) x 90 (W) x 25 (D) (mm)
6-5/16" H x 3-9/16" W x 1" D
* Weight: 240 g (0.53 Ibs.) approx.
WARRANTY
Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period of two years after delivery to the ultimate user and
will repair free of charge or replace at no charge, should it become defective upon which examination shall disclose to be defective and under warranty. Aiphone reserves unto
itself the sole right to make the final decision whether there is a defect in materials and/or workmanship; and whether or not the product is within the warranty. This warranty shall
not apply to any Aiphone product which has been subject to misuse, neglect, accident, or to use in violation of instructions furnished, nor extended to units which have been
repaired or altered outside of the factory. This warranty does not cover batteries or damage caused by batteries used in connection with the unit. This warranty covers bench repairs
only, and any repairs must be made at the shop or place designated in writing by Aiphone. Aiphone will not be responsible for any costs incurred involving on site service calls.
Aiphone will not provide compensation for any loss or damage incurred by the breakdown or malfunction of its products during use, or for any consequent inconvenience or losses
that may result.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.