Table of Contents
Advertisement
6) SATA3 2/3/4/5 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
RAID 1, RAID 5, and RAID 10. Please navigate to the "Configuring a RAID Set" page of GIGABYTE's
website for instructions on configuring a RAID array.
To enable hot-plugging for the SATA ports, please visit the "BIOS Setup," "Settings\IO Ports\SATA
And RST Configuration," webpage of GIGABYTE's website for more information.
7) M2A_SB (M.2 Socket 3 Connector)
The M.2 connector supports M.2 SATA SSDs or M.2 PCIe SSDs and support RAID configuration. Please
note that an M.2 PCIe SSD cannot be used to create a RAID set with a SATA hard drive. Please navigate
to the "Configuring a RAID Set" page of GIGABYTE's website for instructions on configuring a RAID array.
_ F
_ 0
F
7
1
_3
U
110
Follow the steps below to correctly install an M.2 SSD in the
M.2 connector.
Step 1:
Pull the clip's tab up and out of the mounting hole. Slide the
M.2 SSD into the connector at an angle.
Step 2:
Press the M.2 SSD down and then secure it by pressing the
clip's tab into the mounting hole.
- 17 -
7
SATA3
5
4
3
2
1
80
60
42
Chipset supports RAID 0,
®
Pin No. Definition
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
GND
Advertisement
Table of Contents
