Sony STR-D615 Operating Instructions Manual page 12

The remote lets you operate the connected components as
well as the receiver. Press one of the FUNCTION buttons
first to select the program source, then use the following
buttons to operate each component.
The FUNCTION buttons are factory set in the following list.
FUNCTION to be Operating equipment
pressed
TUNER Tuner
TAPE/MD Tape deck
CD CD player
TV/LD TV
VIDEO VCR (VTR 1 mode)
PHONO (The receiver enters the PHONO mode)
This remote commander can control Sony stereo cassette
deck having RMS function.
For more information on the availability of Sony stereo
cassette deck with RMS capability, contact your nearest Sony
dealer.
Turning power of each equipment
W CONTROL ON --
1
Press one of the SYSTEM CONTROL/FUNCTION
button.
This unit and the corresponding equipment are
turned on.
Only for Sony lrv
When you press the VIDEO or TV/LD button, the
power of the TV (VTR or LD player) is also turned on
When an LD player or VTR is selected, the input of
TV switches to VIDEO, and when TV is selected, the
input of TV switches to TV reception mode. (When
you want to turn on the power of TV and switch the
TV input simultaneously, keep pressing the button
you have selected until its power is turned on, or
press the button again after the TV is turned on.)
If the TV input does not switch to the appropriate
mode, switch the input signal with the TV/VIDEO
button.
Note
To operate each equipment correctly, the function
mode of the receiver should be same with that of the
remote commander. So, be sure to press the desired
FUNCTION button at first and then the operative
button.
12
2
Operate the units with each buttons.
The buttons you can operate differ among function
mode see "Operative Buttons".
If you use TV most of time (Only for Sony TV)
You can make remote exclusively for the TV operations by
pressing the TV CONTROL button. The power of TV is
turned on and the TV input automatically switches to the TV
reception mode.
(When you want to perform the turning on the power of TV
and the switching of the TV input simultaneously, press the
TV CONTROL ON button until its power is turned on, or
press the button again after the TV is turned on.)
If the TV input does not switch to the appropriate mode,
switch the input signal with the TV/VIDEO button.
Turning off the power of equipments
By pressing the SYSTEM OFF button, you can turn off the
power of all equipments in system control mode and the
power of TV in TV control mode.
If the power cannot be turned off with the SYSTEM OFF
button, you can turn off the power of each equipment with
the VISUAL POWER button. When you want to turn off the
power while listening to a program source, see "Back ground
operation" on page 13.
Operative buttons
For FM/AM tuner
To Press
Select memory pages for preset tuning SHIFT
Designate preset numbers Numeric buttons
Scan and select preset stations CH PRESET +/-
For tape deck/DAT/MD player
To Press
Designate numbers Numeric buttons
Designate number more than 10 >10
(For tape deck and MD player)
Fastforward
Rewind _b9
Skip selections (For DAT and MD player) _ID4,
Pause play I I
Start play
Start reverse play (For tape deck) "91
Select the tape running direction (For tape RMS DIRECTION
deck having RMS function)
Stop play •
Clear the RMS program contents (For tape RMS CLEAR
deck having RMS function)
Start recording (Forward direction) • +
Start recording (Reverse direction for tape • + -'9
deck)
Program selections (For tape deck having RMS/START
RMS function)