Table of Contents
Advertisement
Operation
If you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-300-BRIGGS (274.447).
Pressure Washer Location
Carbon Monoxide Poisoning
WARNING POISONOUS GAS HAZARD.
Engine exhaust contains carbon monoxide,
a poisonous gas that could kill you in
minutes. You CANNOT smell it, see it, or
taste it. Even if you do not smell exhaust fumes, you
could still be exposed to carbon monoxide gas.
• Operate this product ONLY outside far away from
windows, doors and vents to reduce the risk of carbon
monoxide gas from accumulating and potentially being
drawn towards occupied spaces.
• Install battery-operated carbon monoxide alarms or
plug-in carbon monoxide alarms with battery back-up
according to the manufacturer's instructions. Smoke
alarms cannot detect carbon monoxide gas.
• DO NOT run this product inside homes, garages,
basements, crawlspaces, sheds, or other partially-
enclosed spaces even if using fans or opening doors
and windows for ventilation. Carbon monoxide can
quickly build up in these spaces and can linger for hours,
even after this product has shut off.
• ALWAYS place this product downwind and point the
engine exhaust away from occupied spaces.
If you start to feel sick, dizzy, or weak while using this
product, shut it off and get to fresh air RIGHT AWAY. See a
doctor. You may have carbon monoxide poisoning.
Exhaust port
pointed away from
occupied spaces
Risk of Fire Clearances
WARNING Exhaust heat/gases could ignite
combustibles, structures or damage fuel tank
causing a fire, resulting in death or serious
injury.
• Keep at least 1.5 m (5 ft.) clearance on all sides of
pressure washer including overhead.
How to Start Your Pressure Washer
To start your pressure washer for the first time, follow
these instructions step-by-step. This starting information
also applies if you have let the pressure washer sit idle
for at least a day.
1. Place pressure washer near an outside water
source capable of supplying water at a flow rate
greater than 26.5 liters (7.0 gallons) per minute
and no less than 1.72 BAR (25 PSI) at pressure
washer end of garden hose. DO NOT siphon
supply water.
NOTICE To get maximum performance of the
POWERflow+ Technology, inlet water flow should be
greater than 26.5 LPM (7 GPM).
2. Check that high pressure hose is tightly connected
to spray gun and pump. See Assembly section.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure
washer pump.
NOTICE DO NOT run the pump without the water
supply connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5. Turn ON water, point gun in a safe direction, press
red button and squeeze trigger to purge pump
system of air and impurities.
6. Attach nozzle extension to spray gun. Tighten by
hand.
7. Pull back on collar of nozzle extension, insert 7-in-
1 nozzle and release collar. You may have to twist
7-in-1 nozzle to seat properly in nozzle extension.
Tug on 7-in-1 nozzle to make sure it is securely in
place. See How to Use 7-in-1 Nozzle.
8. Push engine rocker switch (A) to ON (I) position.
A
11
Advertisement
Table of Contents
