Wattage Reference Guide - Generac Power Systems Q-55G Series Owner's Manual

Air-cooled recreational vehicle generators
Hide thumbs Also See for Q-55G Series:
Table of Contents

Advertisement

Do Not Overload the Generator: You can read the
rated wattage/amperage capacity of your generator on
the generator data plate (see 'Identification Record" on
Page 1).
Applying electrical loads in excess of the unit's rated
capacity can bum out the unit and anything connected
to it. Also, overloading trips main circuit breakers.
To avoid overloading, add up the wattage of all con¬
nected electrical lighting, appliance, tool and motor
loads.
This total should not be greater than the
generator's rated wattage capacity.
Most lighting, appliance, tool and motor loads indi¬
cate their required watts on their nameplate or data
plate. For light bulbs, simply note the wattage rating
of the bulb.
If a load does not show its rated wattage, multiply
that load's rated VOLTS times AMPS to obtain
WATTS.
Induction type motors (such as those that run the
vehicle's furnace fan, refrigerator, air conditioner,
etc.) need about 2-1/2 times more watts of power
for starting than for running (for a few seconds
during motor starting). Be sure to allow for this
when connecting electrical loads to the generator.
First, figure the watts needed to start electric motors
in the system.
To that figure, add the running
wattages of other Items that will be operated by the
generator.
Do not apply heavy electrical loads for the first two
or three hours of operation.
WATTAGE REFERENCE GUIDE
RUNNING
WATTS
'Air Conditioner (12,000 Btu).1700
Battery Charger (20 amp). 500
Belt Sander (3').1000
Chain Saw.1200
Circular Saw (6-12/").800 to 1000
Coffee Maker.1000
'Compressor (1 HP).2000
'Compressor (3/4 HP).1800
'Compressor (1/2 HP)..'.1400
Curling Iron.700
'Deep Freeze.500
Disc Sander (9*).1200
Edge Trimmer.500
Electric Nail Gun.1200
Electric Range (one element).1500
Electric Skillet.:.1250
'Furnace Fan (1/3 HP).1200
Hair Dryer.1200
Hand Drill (I").1100
Hand Drill (1/2').750 to 1000
Hand Drill (3/8").500
Hand Drill (1/4').
250
Hedge Trimmer.450
Impact Wrench.500
'Jet Pump.800
RUNNING
WATTS
Lawn Mower.
1200
Light Bulb.100
Microwave Oven.,.700
'Milk Cooler.1100
Oil Burner on Furnace.300
Oil Fired Space Heater (140,000 Btu).400
Oil Fired Space Heater (85,000 Btu).225
Oil Fired Space Heater (30,000 Btu).150
'Paint Sprayer, Airless (1/3 HP).600
Paint Sprayer, Airless (handheld).150
Radio...50 to 200
'Refrigerator.;.600
Slow Cooker.200
'Submersible Pump (1-1/2 HP).2800
'Submersible Pump (1 HP)..2000
'Submersible Pump (1/2 HP).1500
Sump Pump.600
'Table Saw (10").:.1750 to 2000
Television.200 to 500
Weed Trimmer.500
* Allow 2-1/2 times the listed watts for starting these
devices.
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Q-70g series9592-39593-3

Table of Contents