Tire Service Kit - Fiat 124 SPIDER 2019 User Manual

Hide thumbs Also See for 124 SPIDER 2019:
Table of Contents

Advertisement

3. Turn the lug wrench
counterclockwise and lower the vehicle.
Use the lug wrench to tighten the nuts
in the order shown.
Lug Nut Tightening Order
Warning!
To avoid the risk of forcing the vehicle off
the jack, do not tighten the wheel nuts fully
until the vehicle has been lowered. Failure
to follow this warning may result in serious
injury.
4. After tightening the lug nuts, have
them checked with a torque wrench by
an authorized dealer or service station
to verify correct tightness.
158
5. Remove the tire blocks and store
the tools and jack.
6. Check the inflation pressure. Refer
to "Technical Specifications" for more
information.
With TPMS
Do not push the tire pressure
monitoring system set switch after
installing the spare tire. The switch is
only to be pushed after installing the
repaired flat tire or installing a
replacement tire.
Note:
08020303-122-001
To prevent the jack and tool from
rattling, store them properly.
A loose tire or jack thrown forward in a
collision or hard stop could endanger the
occupants of the vehicle. Always stow the
jack parts and the spare tire in the places
provided. Have the deflated (flat) tire
repaired or replaced immediately.
Warning!

TIRE SERVICE KIT

Tire Service Storage
The Tire Service Kit is located inside the
trunk.
Tire Service Kit Location
Note:
Your vehicle is not equipped with a
spare tire. In the event of a flat tire, use
the Tire Service Kit to repair the tire
temporarily. When doing the repair, refer
to the instructions included in the Tire
Service Kit. If an emergency repair was
performed on a flat tire using the Tire
Service Kit, contact an authorized
dealer to repair or replace the tire as
soon as possible.
08020202-121-003

Advertisement

Table of Contents
loading

Table of Contents