Safety instructions Keep children below the age of Installation 8 years old at a safe distance Following installation, ensure from the appliance and power ■ that the back cable. of the dishwasher is not freely accessible (protection Before you switch ON the against contact due to hot appliance surface).
Safety instructions If the dishwasher is installed Do not install the appliance ■ ■ below or above other near heat sources (radiators, domestic appliances, follow heat storage tanks, cookers the information for installation or other appliances which in combination with generate heat) and do not a dishwasher install under a hob.
Safety instructions Childproof lock (door lock) Damage D o o r l o c k The description of the The appliance may be ■ childproof lock is at the back in repaired and opened up by a the envelope. technician only. To do this, disconnect the appliance * depending on model from the power supply.
Page 8
Safety instructions Warning Warning Risk of injury! Risk of explosion! Do not add any solvents To prevent injuries, e.g. ■ to the washing chamber. caused by stumbling, open Danger of explosion! the dishwasher only briefly in order to load and unload Warning the dishwasher.
Protection of the environment Keep children away from ■ Protection of the open dishwasher. There may environment be small parts in the dishwasher which children P r o t e c t io n o f th e e n v i ro n m e n t could swallow and the water Both the packaging of new appliances and the old appliances themselves...
Getting to know your appliance Appliance interior Getting to know your appliance 1" Cutlery drawer G e t tin g to k n o w y o u r a p p l ia n c e 1* Top basket Diagrams of the control panel 12 Upper spray arms and the interior of the appliance can be...
Rinse aid 2. Carefully pour rinse aid up Rinse aid to the max. mark in the filler opening. R in s e a i d As soon as the rinse-aid refill indicator ` is lit on the fascia, there is still a rinse-aid reserve of 1-2 rinsing processes.
Utensils Setting amount of rinse aid Utensils The amount of rinse aid can be set from §:‹‹ to §:‹‡. Please set rinse aid on U te n s ils §:‹… to obtain very good drying results Not suitable (§:‹… is already set in factory). Cutlery and utensils made of wood.
Utensils Loading the dishwasher Cups and glasses Top basket 1* 1. Remove large food remnants. It is not necessary to prerinse utensils under running water. 2. Place the utensils so that – they are secure and cannot tip over. – all utensils with their openings face down.
Utensils Pans Cutlery drawer Bottom basket 1R Arrange the cutlery in the cutlery drawer 1" as illustrated. Separately arranged cutlery is easier to remove after washing. The drawer can be taken out. F olding spikes * F o l d i n g s p i k e s Heavily soiled utensils (pans) should * depending on model be placed in the bottom basket.
Utensils Small accessories holder * Adjusting the height of the S m a l l a c c e s s o r i e s h o l d e r basket * depending on model Light-weight plastic accessories, e.g. The height of the upper utensils basket 1* can be adjusted in 3 stages to cups, lids, etc.
Detergent Adding detergent Detergent 1. If the detergent dispenser 1b is still D e t e r g e n t closed, press the lock 1j to open You can use tablets as well as powder the detergent dispenser. or liquid detergents for dishwashers, but never use washing-up liquid.
Page 17
Detergent 2. Close the cover on the detergent dispenser by sliding it up until the If the utensils are only lightly soiled, lock engages without difficulty. slightly less than the indicated amount of detergent is usually adequate. Suitable detergents and care products can be purchased online via our website or via customer service (see back page).
Overview of programmes Overview of programmes O v e r v i e w o f p r o g r a m m e s The max. possible number of programmes is illustrated in this overview. The corresponding programmes for your appliance can be found on the fascia. The programme data has been measured in the laboratory according to AS/NSZ 2007.
Additional options · Hygiene * Additional options H y g i e n e A d d i tio n a l o p t io n s The temperature is increased during the * depending on model cleaning process. This increases the hygiene status.
Operating the appliance Remaining running time Operating display the appliance When the programme is selected, the O p e r a t in g th e a p p l ia n c e remaining running time of the A qua sensor * programme is indicated on the digital A q u a s e n s o r display h.
Operating the appliance End of programme Switching off the appliance value ‹:‹‹ is indicated on the numerical The programme has ended when the Short time after the end of the programme: display h. 1. Switch off ON/OFF switch (. 2. Turn off the tap (not applicable if Aqua-Stop fitted).
Cleaning and maintenance T erminating the programme Cleaning and T e r m i n a t i n g t h e p r o g r a m m e (Reset) maintenance 1. Press START button P for C le a n i n g a n d m a i n t e n a n c e approx.
Cleaning and maintenance Never use a steam cleaner to clean your Filters dishwasher. The manufacturer is not liable for any consequential damage. The filters 1J keep large foreign Regularly wipe the front of the appliance objects in the rinsing water away from and fascia with a damp cloth;...
Fault, what to do? Spray arms Fault, what to do? F a u l t, w h a t to d o ? Limescale and contaminants in the rinsing water Experience has shown that you can may block nozzles rectify most faults which occur in daily and bearings on the spray arms 12 operation yourself.
Fault, what to do? Waste water pump 6. Check impeller wheel and remove any foreign objects. 7. Place cover in the original position Large food remnants or foreign objects and press down until it engages which were not captured by the filters (click).
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display X lights up. Tap turned off. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be min.
Page 28
Fault, what to do? Fault Cause Remedial action Error code “:ƒˆ is lit. Mains voltage too low. Not an appliance fault, have the mains voltage and electrical installation checked. A different error code is A technical fault has probably Switch off appliances with the ON/OFF switch (.
Page 29
Fault, what to do? Fault Cause Remedial action Utensils not dry. No or too little rinse aid Refill rinse aid. in the dispenser. Programme selected without Select programme with drying (see drying. Overview of programmes, Programme sequence). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
Page 30
Fault, what to do? Fault Cause Remedial action Food remnants Utensils placed too closely Arrange utensils with adequate clearance on the utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
Page 31
Fault, what to do? Fault Cause Remedial action Washable or water-soluble Detergent substances are Change detergent brand. coatings in the container or deposited. These coatings cannot Clean appliance mechanically. on the door. usually be removed with chemicals (appliance cleaner, ...). Only for glasses: Initial glass See Glass and utensil damage.
Page 32
Fault, what to do? Fault Cause Remedial action Removable streaks on Too much rinse aid. Set rinse aid amount to lower setting. glasses, glasses with No rinse aid added or setting too Add rinse aid and check dosage metallic appearance and low.
Page 33
Fault, what to do? Fault Cause Remedial action Cover on the detergent Detergent dispenser or cover Remove detergent residue. dispenser cannot be guide blocked by sticky detergent closed. residue. Detergent residue Spray arms blocked by utensils, Ensure that the spray arms can rotate freely. in the detergent dispenser therefore detergent is not rinsed or in the tablet collecting...
Customer service Customer service Installation and connection C u s to m e r s e r v i c e If you are unable to rectify the fault, In s ta l la t io n a n d c o n n e c t io n please contact your customer service.
Installation and connection Product package Technical specifications If you have any complaints, contact Weight: the dealer where you purchased max. 45 kg the appliance or our customer service. Voltage: Dishwasher ■ 220–240 V, 50 Hz or 60 Hz Instructions for use ■...
Installation and connection Installation Drinking water connection The required installation dimensions can 1. Fasten the drinking water connection be found in the installation instructions. to the tap according Level the appliance with the aid of the to the installation instructions using height-adjustable feet.
Installation and connection Electrical connection Removing the appliance Connect the appliance to an Also observe ■ alternating current only, ranging from the sequence of worksteps here. 220 V to 240 V and 50 Hz or 60 Hz 1. Disconnect the appliance from via a correctly installed socket with the power supply.
Installation and connection Transportation Protection against frost P r o t e c t i o n a g a i n s t f r o s t ( E m p t y i n g t h e a p p l i a n c e ) Empty the dishwasher and secure loose If the appliance is in a room where there parts.
Page 40
0.03 € per minute at peak. Off peak 0.0088 € per minute. US 800 944 2904 toll-free Contact information for all countries can be found on the enclosed customer service list. Robert Bosch Hausgeräte GmbH Carl-Wery-Straße 34 81739 München Germany www.bosch-home.com...