Polaris Hawkeye 325 2X4 2016 Owner's Manual For Maintenance And Safety page 103

Engine Oil
Oil and Filter Change (325)
10. Place shop towels beneath the
filter cover to catch oil drips.
Remove the cover screws and
remove the cover to access the
oil filter.
11. Remove the oil filter and spring,
retaining the spring for
reinstallation.
12. Using a clean dry cloth, clean
the surface of the crankcase.
Inspect for debris in the oil filter
bore.
13. Lubricate the o-ring for the new filter with a film of fresh engine oil.
Check to make sure the o-ring is in good condition. Install the o-
ring to the filter cover.
14. Reinstall the oil filter spring, then install the new filter.
15. Reinstall the oil filter cover and o-ring. Torque the screws to 88 in-
lbs (10 Nm).
16. Add 1.75 quarts (1.65 l) of the recommended oil. Reinstall the
dipstick.
17. Place the transmission in PARK.
18. Lock the parking brake.
19. Start the engine. Allow it to idle for one to two minutes.
20. Stop the engine.
21. Check for leaks.
22. Check the oil level. Add oil as needed to bring the level to the upper
mark on the dipstick.
23. Dispose of used filter and oil properly.
MAINTENANCE
Filter Cover
Bore
101