Table of Contents
Advertisement
en Basic operation
Requirement: The laundry is pre-
pared.
→ "Laundry", Page 30
Open the door.
1.
Make sure that the drum is empty.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
13.5 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note: Observe the information about
detergents and care products
→ Page 31.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 19
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.6 Starting the programme
Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Start/Reload
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
32
.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: -0-.
13.7 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start/Re-
.
load
To resume the programme, after
3.
the desired soaking time, press
Start/Reload
13.8 Adding laundry
Press Start/Reload
1.
The appliance pauses.
appears, it is not pos-
Note: If
sible to add laundry.
When
goes out, it is possible to
add laundry.
Open the appliance door.
2.
Add or remove laundry.
3.
Close the appliance door.
4.
Press Start/Reload
5.
13.9 Cancelling the pro-
gramme
Press Start/Reload
1.
Open the appliance door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
Rinse programme.
.
.
.
.
Advertisement
Table of Contents
