Electrolux HOB655NF User Manual page 32

When the function is set to
the sounds only when:
• you touch
• Minute Minder comes down
• Count Down Timer comes down
• you put something on the control panel.
5.14 Power management
If multiple zones are active and the
consumed power exceeds the limitation of
the power supply, this function divides the
available power between all cooking zones
(connected to the same phase). The hob
controls heat settings to protect the fuses of
the house installation.
• If the hob reaches the limit of maximum
available power (refer to the rating plate),
the power of the cooking zones will be
automatically reduced.
• The heat setting of the cooking zone
selected last is always prioritised. The
remaining power will be divided between
the previously activated cooking zones in
reverse order of selection.
• The heat setting display of the reduced
zones changes between the initially
selected heat setting and the reduced
heat setting.
• Wait until the display stops flashing or
reduce the heat setting of the cooking
zone selected last. The cooking zones will
continue operating with the reduced heat
setting. Change the heat settings of the
cooking zones manually, if necessary.
5.15 Hob²Hood
It is an advanced automatic function which
connects the hob to a special hood. Both the
hob and the hood have an infrared signal
communicator. Speed of the fan is defined
automatically on basis of mode setting and
temperature of the hottest cookware on the
hob. You can also operate the fan from the
hob manually.
For most of the hoods the
remote system is originally
deactivated. Activate it before
you use the function. For more
information refer to hood user
manual.
32 ENGLISH
Operating the function automatically
you can hear
To operate the function automatically set the
automatic mode to H1 – H6. The hob is
originally set to H5. The hood reacts
whenever you operate the hob. The hob
recognizes temperature of the cookware
automatically and adjusts the speed of the
fan.
Automatic modes
1) The hob detects the boiling process and acti‐
vates fan speed in accordance with automatic
mode.
2) The hob detects the frying process and acti‐
vates fan speed in accordance with automatic
mode.
3) This mode activates the fan and the light and
does not rely on the temperature.
Changing the automatic mode
1. Deactivate the hob.
2. Press
3. Press
4. Press
5. Press
Automatic
light
Mode H0 Off
Mode H1 On
Mode On
3)
H2
Mode H3 On
Mode H4 On
Mode H5 On
Mode H6 On
for 3 seconds. The display
comes on and goes off.
for 3 seconds.
a few times until
of the timer to select an
automatic mode.
To operate the hood directly on
the hood panel deactivate the
automatic mode of the function.
Boiling 1) Frying 2)
Off Off
Off Off
Fan speed Fan speed
1 1
Off Fan speed
1
Fan speed Fan speed
1 1
Fan speed Fan speed
1 2
Fan speed Fan speed
2 3
comes on.