Table of Contents
Advertisement
NOTE: If the limiter straps are
adjusted, it is highly recommended
that at least a minimum of 3.2 mm
(1/8 in.) preload on the shock spring
be maintained.
! WARNING
Do not adjust the front arm limiter
straps to a point at which steering
and operator control of the snowmo-
bile are adversely affected.
Adjusting Skid Frame Rear
Shock (Limited Models)
To adjust the damping, use the adjust-
ment lever located above the EVOL
chamber on the shock. There are three
settings that may be chosen: 1, 2, or 3.
Adjusting Rear Spring Pre-
Load
Proper adjustment of rear spring pre-load
is necessary to get the most desirable
ride. The chart is designed to help in set-
ting up rear spring pre-load; however,
riding style is the single greatest factor in
determining rear spring requirements.
Rider Weight (lb)
Up to 80 kg (180 lb)
80 kg (180 lb) - 110 kg (240 lb)
Over 110 kg (240 lb)
NOTE: These cam position set-
tings are suggestions only. Personal
riding style will greatly influence
cam position settings. Spend time to
determine setting preferences.
36
Rear spring pre-load adjustment is accom-
plished by rotating the adjusting cams.
Position 3 provides the stiffest ride, and
position 1 is for the light driver or slow-
speed trail riding. Position 2 is for the
average operator under normal conditions.
Always rotate the cam from the lighter
position to the heavier position.
Never force the adjustment cams
from the low position to the high
position. Cam damage may occur.
To rotate an adjusting cam, use the spark
plug wrench from the tool kit. Rotate the
wrench until the cam is in the desired
position. To stiffen the ride, rotate the cam
SNO-550
so as to raise the spring end. Make the
appropriate adjustment on the other cam.
Lights
For the correct headlight bulb and/or tail-
light/brakelight LED, see the appropriate
specifications sheet.
Removing and Installing
Taillight/Brakelight
These models are equipped with an LED
Cam Position
taillight/brakelight. If the LED fails, it
1
must be replaced.
2
1. Disconnect the taillight harness con-
3
2. Remove the two machine screws
CAUTION
nector.
securing the taillight to the bracket.
741-450A
Advertisement
Table of Contents
