Table of Contents
Advertisement
12
INSTALLATION
Removing/Assembling the
Freezer Drawer Handle
Removing the Handles
1
Loosen the set screws
lower side of the handle with a
wrench and remove the handle.
2
Loosen the mounting fasteners
connect to the
freezer drawer
and handle
1
using a
/
in.
4
Allen wrench,
and remove
the mounting
fasteners.
Assembling the Handles
1
Assemble the mounting fasteners
both ends of the handle using a
wrench.
2
Place the handle on the door by fitting
the handle
footprints over
the mounting
fasteners and
tightening the
set screws
1
with a
/
in.
8
Allen wrench.
WARNING
When assembling or disassembling the
handle:
Grasp the handle tightly to avoid dropping it.
y
Do not swing the handle into nearby people
y
or animals.
Make sure that the bracket hole of the
y
handle fits properly into the stopper bolt of
the door. Assemble the set screws to fix
the handle into place.
Make sure that there is not a gap between
y
the door and handle after assembling the
handle.
Removing/Assembling the
Doors and Drawers
When it is necessary to move the fridge
through a narrow opening, removing the doors
is the recommended procedure.
located on the
1
/
in. Allen
8
y
that
y
y
y
at
y
1
/
in. Allen
4
y
WARNING
If your entrance door is too narrow for
the fridge to pass through, remove the
fridge doors and move the fridge sideways
through the doorway.
Use two or more people to remove and
install the fridge doors. Failure to do so can
result in back or other injury.
Disconnect the electrical supply to the
fridge before installing. Failure to do so
could result in serious injury or death.
Do not put hands, feet or other objects
into the air vents or bottom of the fridge.
You may be injured or receive an electrical
shock.
Be careful when handling the hinge and
stopper, to avoid injury.
Remove food and bins before detaching the
doors and drawers.
Advertisement
Table of Contents
