Table of Contents
Advertisement
[1] Specifications of HZL-UX8
(1) Power switch
• 220-240V AC common to 50/60 Hz
• 120V AC common to 60 Hz
(2) Power consumption
• 90 W
(3) Dimensions and weight
• Dimensions
• Weight
(4) Revolution control
• Slide style speed control
Straight stitch
Pattern stitch
Reverse stitch
Bobbin winding
Low-speed start
• Foot controller
Even when the foot controller is used, the speed control function by means of the slider is effective.
To stop the machine, either release the foot controller or press start/stop button.
The number of revolutions is controlled in the way same with the case of the slide speed control.
Toe-up pedaling function can be set optionally.
• Safety control
When the motor shaft of the sewing machine is accidentally constrained, the power supply to the motor is
stopped within two seconds.
When the motor is overheated, the built in thermal switch stops the power to the motor.
Note that the machine can be restarted once the motor spontaneously cools down.
(5) Stop position
• Upon finishing sewing, the machine stops according to the preset needle stop position (with its needle up or
down).
• Upon finishing reverse stitching, the machine stops with its needle down.
• Needle moves down when the machine has preset so that the needle stops at its up position and needle up/
down button is pressed.
• Needle moves up when the machine has preset so that the needle stops at its down position and needle up/
down button is pressed.
• In the case of fault, the machine stops immediately (stop position varies).
(6) Zigzag width
• Max. 7 mm depending on the pattern selected
(7) Amount of feed
• The amount of feed is changed in increments of 0.2 mm by the stitch length adjusting dial (or button).
(For the parallel parts of a buttonhole and satin stitches, the amount feed is changed in increments of 0.1 mm.)
Default setting: 2.4 mm (for straight stitching)
Main unit: 602 (width) × 264 (depth) × 310 (height) (mm)
Main unit: 14.9 kg
80 to 1,050 sti/min (SPM)
80 to 750 sti/min (SPM)
80 to 1,050 sti/min (SPM)
(Sewing speed other than the specified range can be set optionally.)
80 to 1,050 sti/min (SPM) (when the speed controller is used.)
1,500 to 3,000 sti/min (SPM)
80 to 110 sti/min (SPM) (approx. 1 second only when the power switch is turned ON.)
– 1 –
Advertisement
Table of Contents
