Table of Contents
Advertisement
Trouble shooting
en
3Trouble shooting
Faults often have simple explanations. Please read the
T r o u b l e s h o o t i n g
notes in the table before calling the after-sales service.
Display
Fault
None
The power supply has been disconnected.
All displays flash
The touch control is wet or an object is resting
on it.
Several hotplates have been used over a pro-
"ƒ
longed period at high power settings. To pro-
tect the electronics, the hotplate has been
switched off.
Despite the switch-off by "ƒ, the electronics
"...
have become hot again. All hotplates have
therefore been switched off.
"†and the heat setting
Warning: There is a hot pan in the area of the
flash alternately. An
control panel. There is a risk that the electron-
audible signal can be
ics will overheat.
heard
"†and audible signal
There is a hot pan in the area of the control
panel. To protect the electronics, the hotplate
has been switched off.
The hotplate was in operation for too long and
"‰
has switched itself off.
š" The hotplates do
Demo mode is switched on
not heat up
E-report in the displays
When an error message with "E" appears in the display,
e.g. E0111, switch the appliance off and on again.
If it was a one-off error, the display goes out. If the error
message appears again, call the after-sales service and
quote the exact error message.
12
The electronics of your hob are underneath the control
panel. For various reasons, the temperature in this area
may rise sharply.
In order that the electronics do not overheat, the
hotplates are switched off as and when necessary. The
"ƒ, "..., or "† display appears alternately with the • or
œ residual heat indicator.
Measure
Check the household fuse for the appliance. Check whether there is a
power cut by trying other electronic appliances.
Dry the control or remove the object.
Wait a while. Touch any touch control. When "ƒ goes out, the electronics
have cooled down sufficiently. You can continue cooking.
Wait a while. Touch any touch control. When "... goes out, you can con-
tinue cooking.
Remove the pan. The fault display goes out shortly afterwards. You can
continue cooking.
Remove the pan. Wait a while. Touch any control. When "† goes out, you
can continue cooking.
You can switch the hotplate back on again immediately.
Switching off the demo mode: Disconnect the appliance for 30 seconds
from the power supply (switch off the household fuse or the circuit breaker
in the fuse box). Touch any touch control after 3 minutes. The demo mode
is switched off.
Advertisement
Table of Contents
