Before First Use; Filling With Water; Setting Temperature; Steam Ironing - Vox DBL-5025 Operating Instructions Manual

BEFORE FIRST USE

1. It is normal for small amount of smoke to be produced for the first time, this will
quickly disappear.
2. When using the steam function for the first time, do not direct the steam towards
the laundry, as there could be debris from the steam vents.

FILLING WITH WATER

1. We recommend the use of distilled water.
2. Make sure that both the Steam Control turning Knob and Temperature Control
Dial are in "OFF" position.
3. Hold the iron upright so that the water-filling inlet is in a horizontal position.
4. Fill with water through Water Filling Inlet until the water reach the "MAX" mark
indicated on the side of the iron, and never fill above this mark.

SETTING TEMPERATURE

Follow the ironing instructions on the garment label. If there is no instruction and
you do not know the kind of fabric, please consult the following table.
Note: If the fabric consists of various kinds of fabrics, always select the
temperature required by the most delicate fabrics.
Fabric Temperature control
•
Synthetic
• •
Silk, wool
Cotton, linen • • •

STEAM IRONING

– Place the iron in a vertical position and set the temperature control dial at the
minimum/low heat setting.
– Insert the plug into the socket, and then turn the temperature control dial to the
"high heat" marking. The pilot light will come on, indicating that the iron is heating
up.
– When the pilot light turns off, the set temperature has been reached and the iron is
ready to use.
– During ironing the pilot light on the iron automatically switches on/off as the
thermostat maintains the set temperature (you may continue ironing during this
process).
– Turn the steam control turning knob to the required position.
– Steam is produced as soon as the iron in held horizontally.
Temperautre requirement
Low temperature
Medium temperature
High temperature
3