Connecting To An Access Point In Infrastructure Mode; To Configure An Infrastructure Mode Profile - NETGEAR WG311v3 Reference Manual

Reference Manual for the NETGEAR 802.11g Wireless PCI Adapter WG311v3
• MAC Address: Identifies the hardware address (MAC Address) of the wireless device
broadcasting this information.
• Mode: Identifies the type of wireless network — Access Point (Infrastructure) or
Computer-to-computer (Ad-Hoc).
To connect to a network:
1. Click Scan to view the available networks.
2. Click on the column header to sort for better viewing if you have many networks.
3. Double-click to connect to the SSID.
4. The highlighted SSID is the one currently connected.

Connecting to an Access Point in Infrastructure Mode

This section provides instructions for configuring the NETGEAR 802.11g Wireless PCI Adapter
WG311v3 to connect to a wireless access point.

To Configure an Infrastructure Mode Profile

Follow the instructions below to configure an infrastructure mode profile for connecting to an
access point.
1. Run the WG311v3 Configuration Utility.
Click the WG311v3 icon
Figure 3-2: Settings tab page
Configuration
in the Windows system tray to open the Settings tab page.
3-3