Biostar P4VTB Manual page 48

P4VTB BIOS Setup
AGP Driving Control
By choosing "Auto" the system BIOS will the AGP output Buffer Drive strength
P Ctrl by AGP Card. By choosing "Manual", it allows user to set AGP output
Buffer Drive strength P Ctrl by manual.
The Choices: Auto (default), Manual.
AGP Driving Value
While AGP driving control item set to "Manual", it allows user to set AGP
driving.
The Choices: DA (default).
AGP Fast Write
The Choices: Enabled, Disabled (default).
AGP Master 1 WS Write
When Enabled, writes to the AGP (Accelerated Graphics Port) are executed with
one wait states.
The Choices: Disabled (default), Enabled.
AGP Master 1 WS Read
When Enabled, read to the AGP (Accelerated Graphics Port) are executed with
one wait states.
The Choices: Disabled, Enabled (default).
AGP 3.0 Calibration cycle
This item allows you to disable or enable the AGP 3..0 Calibration Cycle.
The Choices: Enabled (default), Disabled.
CPU & PCI Bus Control
If you highlight the literal "Press Enter" next to the "CPU & PCI Bus Control" label and
then press the enter key, it will take you a submenu with the following options:
PCI Master 0 WS Write
When Enabled, writes to the PCI bus are executed with zero-wait states.
The Choices: Enabled (default), Disabled.
PCI Delay Transaction
The chipset has an embedded 32-bit posted write buffer to support delay
transactions cycles. Select Enabled to support compliance with PCI specification
version 2.1.
The Choices: Enabled (default), Disabled.
VLink 8X Support
The Choices: Enabled (Default), Disabled.
15