Samsung AC TN4P Series User Manual page 19

Problem
The air conditioner
does not operate
immediately after it
has been restarted.
The wired remote
control does not
operate.
The air conditioner
is not turned on or
off immediately
with the wired
remote control.
The Timed on/off
function does not
operate.
The indoor unit
display blinks
continuously.
I want to get cooler
air.
The air is not cool
or warm enough.
Because of the protective mechanism, the appliance does not start
operating immediately to keep the unit from overloading. The air
conditioner will start in 3 minutes.
Check whether the
remote control display. In this case, turn off both the air conditioner
and the auxiliary power switch, and then contact a service centre.
Check whether the wired remote control is set for group control. In this
case, the air conditioners connected to the wired remote control are
turned on or off sequentially. This operation takes up to 32 seconds.
Check whether you pressed the
after setting the on/off time. Set the on/off time.
Turn on the air conditioner again by pressing the
Turn off and then turn on the auxiliary power switch, and then turn on
the conditioner.
If the indoor unit display is still blinking, contact a service centre.
Operate the air conditioner with a electric fan to save energy and
enhance the cooling efficiency.
In the Cool mode, cool air does not come out if the set temperature is
higher than the current temperature.
Press the Temperature button repeatedly until the set temperature
In the Heat mode, warm air does not come out if the set temperature is
lower than the current temperature.
Press the Temperature button repeatedly until the set temperature
Solution
indicator is displayed at the bottom right of the
(SET) button on the remote control
(Power) button.
19
English