Asus H110M-K X Manual page 11

Intel H110 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~4)
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA
6.0 Gb/s signal cables.
When using hot-plug and NCQ, set the SATA Mode Selection item in the BIOS to
[AHCI].
USB 3.0 connectors (20-1 pin USB3_12)
Connect a USB 3.0 module to any of these connectors for additional USB 3.0
front or rear panel ports. This connector complies with USB 3.0 specifications and
provides faster data transfer speeds of up to 5 Gbps, faster charging time for USB-
chargeable devices, optimized power efficiency, and backward compatibility with
USB 2.0.
Clear RTC RAM (2-pin CLRTC)
This header allows you to clear the CMOS RTC RAM data of the system setup
information such as date, time, and system passwords.
To erase the RTC RAM:
1. Turn OFF the computer and unplug the power cord.
2. Use a metal object such as a screwdriver to short the two pins.
3. Plug the power cord and turn ON the computer.
4. Hold down the <Del> key during the boot process and enter BIOS setup to
re-enter data.
USB 2.0 connector (10-1 pin USB910)
Connect the USB module cable to any of these connectors, then install the module
to a slot opening at the back of the system chassis. This USB connector complies
with USB 2.0 specifications and supports up to 480Mbps connection speed.
Digital audio connector (4-1 pin SPDIF_OUT)
Connect the S/PDIF Out module cable to this connector, then
install the module to a slot opening at the back of the system
chassis.
TPM connector (14-1 pin TPM)
Connect a Trusted Platform Module (TPM) system to this connector to enhance
network security, protect digital identities, and ensure platform integrity.
PIN 1
SPDIF_OUT
ASUS H110M-K X
If the steps above do not help, remove the onboard battery and short the
two pins again to clear the CMOS RTC RAM data. After clearing the CMOS,
reinstall the battery.
TPM
+3VSB F_CLKRUN
S_PCIRST#_TBD F_SERIRQ
F_FRAME#
GND F_LAD3
C_PCICLK_TPM F_LAD2
F_LAD1
+3V
+3V F_LAD0
PIN 1
CLRTC
PIN 1
1-3