Kenwood KM-105 Instruction Manual page 5

Speakers
Setting SPEAKER IMPEDANCE SELECTOR
(Except U.S.A. and Canada)
According to the impedance of the speakers used, set
the SPEAKER
IMPEDANCE
SELECTOR
at rear as
follows.
40,60 "LESS THAN 8 Q"
8, 160 "8 Q OR MORE"
SPEAKER IMPEDANCE
SELECTOR
<>
LESS THAN 82
8a OR MORE
'Notes:
1.. During speaker system connection and operation of SPEAKER IM-
PEDANCE SELECTOR, set the POWER switch to OFF.
WARNING!
Connecting speaker cords
1. Stripe the insulation from the cord as shown below.
10mm @
Remove insulation
= from lead tip.
Twist wire tightly,
ssf and solder.
<6 ® YY ©
a
ae
a— [Er | EP
insert the wire and
return the lever,
The wire is
Press the lever.
now locked.
Speaker lead connection
INPUT jacks
Note:
To prevent possible trouble, always disconnect the power
plug or
turn off the POWER
switch before connecting or disconnecting the
audio cables.
Note:
Be sure to connect the speaker cords before connecting
the AC
OUTLET.
KM-105/KM-205(K) §